900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf






Pericom Semiconductor

PI3CH200 Datasheet Preview

PI3CH200 Datasheet

2-Bit Bus Switch

No Preview Available !

PI3CH200
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
2-Bit Bus Switch, Enable Low 1.8V/2.5V/3.3V,
High-Bandwidth, Hot Plug
Features
Description
Near-Zero propagation delay
5-ohm switches connect inputs to outputs
High signal passing bandwidth (500 MHz)
Beyond Rail-to-Rail switching
- 0 to 5V switching with 3.3V power supply
- 0 to 3.3V switching with 2.5V power supply
5V I/O tolerant with supply in OFF and ON state
1.8V, 2.5V and 3.3V supply voltage operation
Hot Insertion Capable
Industrial Operating Temperature: -40ºC to +85ºC
8kV ESD Protection (human body model)
Latch-up Performance: >200mA per JESD17
Packaging (Pb-free & Green available):
-8-pin TSSOP (L)
The PI3CH200 is a low voltage, 2-channel switch
designed with fast individual enables. The switch
introduces no additional ground bounce noise or
additional propagation delay.
The PI3CH200 device has active low enables. It is
very useful in switching signals that have high
bandwidth (500 MHz).
Applications
High Bandwidth Data Switching
Hot-Docking
Analog Signal Switching
Differential Signal Switching
Pin Configuration
Block Diagram
Pin Description
Pin No
1, 7
2, 5
3, 6
4
8
Pin Name
1111111
EN1, EN2
A1, A2
B1, B2
GND
VCC
EN1
A2 B2
EN2
Description
Switch Enables
A Ports
B Ports
Ground
Power
Truth Table(1)
ENx Ax
X Hi-Z
H Hi-Z
L Bx
Note:
Bx
Hi-Z
Hi-Z
Ax
VCC
GND
VCC
VCC
Function
Disconnect
Disconnect
Connect
1. H=High Voltage Level; L=Low Voltage Level;
Hi-Z=High Impedance
2015-07-0022
PT0479-3 08/05/15
1




Pericom Semiconductor

PI3CH200 Datasheet Preview

PI3CH200 Datasheet

2-Bit Bus Switch

No Preview Available !

|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
PI3CH200
2-Bit Bus Switch, Enable Low1.8V/2.5V/
3.3V, High-Bandwidth, Hot Plug
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Maximum Ratings
StorageTemperature...................................................................................-65oC to +150oC
Ambient Temperaturewith Power Applied........................................40°C to +85°C
SupplyVoltage to Ground Potential............................................................-0.5Vto +4.6V
DC Input Voltage ............................................................................................-0.5Vto +6.0V
DC Output Current.......................................................................................... 120mA
Power Dissipation..............................................................................................................0.5W
Note:
Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the
device. This is a stress rating only and functional
operation of the device at these or any other condi-
tions above those indicated in the operational sec-
tions of this specification is not implied. Exposure
to absolute maximum rating conditions for extended
periods may affect reliability.
DC Electrical Characteristics
3.3V supply (Over operating range, TA = -40 ~ +85ºC, VCC=3.3V±10%, unless otherwise noted)
Symbol
Description
Test Conditions(1)
Min Typ(2) Max Unit
VIH Control Input HIGH Voltage
Guaranteed Logic HIGH Level
2.0
-
-V
VIL Control Input LOW Voltage
Guaranteed Logic LOW Level
-0.5
-
0.8
VIK Clamp Diode Voltage
VCC = Min., IIN = -18mA
- -1.3 -1.8
IIH Input HIGH Current
VCC = Max., VIN = VCC
- - ±1
IIL Input Low Current
VCC = Max., VIN = GND
- - ±1
IOZH High-Impedance Current
0 ≤ A, B VCC
- - ±1
RON Switch On-Resistance(3)
VCC = Min., VIN = 0.0V
ION = -48mA or -64mA
VCC = Min., VIN = 3.6V
ION = -15mA
- 46
- 58
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at VCC = 3.3V, TA = 25°C ambient and maximum loading.
3. Measured by the voltage drop between A and B pin at indicated current through the switch. On-Resistance is determined
by the lower of the voltages on the two (Ax, Bx) pins.
V
V
μA
μA
μA
2.5V supply (Over operating range, TA = -40 ~ +85ºC, VCC=2.5V±10%, unless otherwise noted)
Symbol
Description
Test Conditions(1)
Min
Typ(2)
Max
VIH Control Input HIGH Voltage
Guaranteed Logic HIGH Level
1.8
- VCC+0.3
VIL Control Input LOW Voltage
Guaranteed Logic LOW Level
-0.3
-
0.8
VIK Clamp Diode Voltage
VCC = Max., IIN = -6mA
- -0.7 -1.8
IIH Input HIGH Current
VCC = Max., VIN = VCC
- - ±1
IIL Input Low Current
VCC = Max., VIN = GND
- - ±1
IOZH High-Impedance Current
0 ≤ A, B VCC
- - ±1
RON Switch On-Resistance(3)
VCC = Min., VIN = 0.0V
ION = -48mA
- 48
VCC = Min., VIN = 2.25V
ION = -15mA
-
7 14
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at VCC = 2.5V, TA = 25°C ambient and maximum loading.
3. Measured by the voltage drop between A and B pin at indicated current through the switch. On-Resistance is determined
by the lower of the voltages on the two (Ax, Bx) pins.
Unit
V
V
V
μA
μA
μA
2015-07-0022
PT0479-3 08/05/15
2


Part Number PI3CH200
Description 2-Bit Bus Switch
Maker Pericom Semiconductor
PDF Download

PI3CH200 Datasheet PDF






Similar Datasheet

1 PI3CH200 2-Bit Bus Switch
Pericom Semiconductor





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z



Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy