PI2EQXDP101-A Datasheet | Pericom Semiconductor

PI2EQXDP101-A 1 to 1 DisplayPort™ ReDriver™ Features - DisplayPort™ 1.1a operation at reduced bit rate (1.62Gbps) and high bit rate (2.7Gbps) - Jitter elimination circuits automatically adjust link via training path àà Pre-Emphasis, and output swing - Can support all 4 levels of output swing and 4 levels output pre-emphasis, as specified in the DisplayPort 1.1a spec. - AUX interception circuit only listens to the link training, but does not affect link training - Low insertion loss across the AUX signal path (0.35dB @1Mbps) - Output can support dual mode DP by providing DDC signals across the AUX_sink pins àà Using Cable Detect pin from DP connector (pin 13), the switch can toggle between DP and TMDS mode. - Automatic power down state when HPD signal is LOW - Enters low power mode when no data signal is present - Dual power supply (1.5V and 3.3V) - 2KV HBM ESD protection - 50 ohm output termination can be turned off when port is off àà Port is turned off automatically when not needed - Package (Pb-Free & Green available) àà 36-pin TQFN (ZF) Description The PI2EQXDP101-Ais a one Input and one Output DisplayPort™ ReDriver™ that support a maximum data rate of 2.7 Gbps through each channel, which results in a total of 10.8Gbps through-put. Output Level Swing and Output Pre-emphasis and number of active lanes are controlled by decoding the AUX mand during link initialization. Also, utilizing the HPD signals from each DisplayPort port, the PI2EQXDP101-A can automatically enter power down state. Or, if the graphics driver is off and has no output signal, Peri’s PI2EQXDP101-A can automatically enter low power mode, even if an active monitor is attached. Block Diagram Pin Diagram (Top-side View) VDD33 DDC_SDA DDC_SCL AUX_SRC+ AUX_SRCDDC_SCL/AUX+...