P4SMAJ-AU SERIES
SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR POWER 400 Watt
STAND-OFF VOLTAGE
5 to 220 Volt
FEATURES
• For surface mounted applications in order to optimize board space.
• Glass passivated junction
• Low inductance
• Plastic package has Underwriters Laboratory Flammability
Classification 94V-O
• High temperature soldering : 260°C /10 seconds at terminals
• Acquire quality system certificate : TS16949
• AEC-Q101 qualified
• ESD IEC-61000-4-2 Air + 30kV, Contact + 30kV
• Lead free in compliance with EU RoHS 2011/65/EU directive
• Green molding compound as per IEC61249 Std. . (Halogen Free)
MECHANICAL DATA
• Case: JEDEC DO-214AC,Molded plastic over passivated junction
• Terminals: Solder plated,solderable per MIL-STD-750, Method 2026
• Polarity: Color band denotes cathode end
• Standard Packaging: 12mm tape (EIA-481)
• Weight: 0.002 ounce, 0.064 gram
0.181(4.60)
0.157(4.00)
0.012(0.305)
0.006(0.152)
0.060(1.52)
0.030(0.76)
0.008(0.203)
0.002(0.051)
0.208(5.28)
0.188(4.80)
DEVICES FOR BIPOLAR APPLICATIONS
For Bidirectional use C or CA Suffix for types P4SMAJ5.0 thru types P4SMAJ220.
Electrical characteristics apply in both directions.
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25°C ambient temperature unless otherwise specified.
Rating
Symbol
Value
Peak Pulse Power Dissipation on T A = 25OC (Notes 1,2,5, Fig.1)
PPP 400
Units
Watts
Peak Forward Surge Current per Fig.5 (Notes 3)
Peak Pulse Current on tp=10/1000μs waveform (Notes 1) Fig.2
Typical Thermal Resistance Junction to Air (Notes 2)
ESD IEC-61000-4-2 (Air)
ESD IEC-61000-4-2 (Contact)
Operating Junction and Storage Temperature Range
IFSM
IPPM
RθJA
VESD
TJ,TSTG
40
see Table 1
70
+30
+30
-55 to +150
Amps
Amps
OC / W
kV
OC
NOTES :
1. Non-repetitive current pulse, per Fig.3 and derated above TA = 25OC per Fig. 2.
2. Mounted on 5mm2 copper pads to each terminal.
3. 8.3ms single half sine-wave, or equivalent square wave, duty cycle = 4 pulses per minutes maximum.
4. Lead temperature at 75OC = T .
L
5. Peak pulse power waveform is tp=10/1000μs.
6. A transient suppressor is selected according to the working peak reverse voltage (VRWM), which should be equal to or
greater than the DC or continuous peak operating voltage level.
May 4,2016-REV.11
PAGE . 1