Datasheet4U Logo Datasheet4U.com

NCP81038 - Synchronous Buck Controller

Description

Pin No.

channel MOSFET.

Top gate driver input supply, a bootstrap capacitor connection between SWNx and this pin.

Switch node between the top MOSFET and bottom MOSFET.

Features

  • Wide Input Voltage Range: from 5.5 V to 28 V.
  • Built.
  • in 5 V / 60 mA LDO.
  • Built.
  • in selectable 3.3 V or 12 V / 10 mA LDO.
  • Three Selectable Fixed Frequency 300 KHz, 400 KHz or 600 KHz.
  • 180 Interleaved Operation Between the Two Channels in Continue.
  • Conduction.
  • Mode (CCM).
  • Selected Power.
  • Saving Mode/Forced PWM Mode.
  • Transient.
  • Response.
  • Enhancement (TRE) Control.
  • Input Supply V.

📥 Download Datasheet

Datasheet Details

Part number NCP81038
Manufacturer onsemi
File Size 180.52 KB
Description Synchronous Buck Controller
Datasheet download datasheet NCP81038 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
NCP81031 Low Voltage Synchronous Buck Controller onsemi
NCP81022 Dual Output 4 Phase Plus 1 Phase Digital Controller onsemi
NCP802 Highly Integrated Lithium Battery Protection ON
NCP-NFJ C15 Type Accessories Hirose Electric
NCP-NFP C15 Type Accessories Hirose Electric

Other Datasheets by onsemi

Part Number Description
NCP81039 Synchronous Buck Controller
NCP81040 Programmable Multi-Phase Synchronous Buck Converter
NCP81042 Precise Low Voltage Synchronous Buck Controller
NCP81044 Low Voltage Synchronous Buck Controller
NCP81045 Single Synchronous Step-Down Controller

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
NCP81038 Synchronous Buck Controller with Auto Power Saving Mode and Built-In LDO NCP81038 is a dual synchronous buck controller that is optimized for converting the battery voltage or adaptor voltage into multiple power rails required in desktop and notebook system. NCP81038 consists of two buck switching controllers with fixed 5.0 V output on channel 2, 3.3 V on channel 1 and two on−board LDOs with three outputs: 5 V / 60 mA and 3.3 V or 12 V / 10 mA. NCP81038 supports high efficiency, fast transient response and provides power good signals. ON Semiconductor proprietary adaptive−ripple control enables seamless transition from CCM to DCM, where converter runs at reduced switching frequency with much higher efficiency at light load. The part operates with supply voltage ranging from 5.