FUSB302B
FUSB302B is Programmable USB Type-C Controller manufactured by onsemi.
Description
The FUSB302B targets system designers looking to implement a DRP/SRC/SNK USB Type-C connector with low amount of programmability.
The FUSB302B enables the USB Type-C detection including attach, and orientation. The FUSB302B integrates the physical layer of the USB BMC power delivery protocol to allow up to 100 W of power and role swap. The BMC PD block enables full support for alternative interfaces of the Type-C specification.
Features
- Dual-role Functionality with Autonomous DRP Toggle
- Ability to Connect as Either a Host or a Device Based on What Has
Been Attached
- Software Configurable Either as a Dedicated Host, Dedicated
Device, or Dual Role
- Dedicated Devices can Operate both on a Type-C Receptacle or a Type-C Plug with a Fixed CC and VCONN Channel
- Full Type-C 1.2 Support. Integrates the Following Functionality of the CC Pin:
- Attach/Detach Detection as Host
- Current Capability Indication as Host
- Current Capability Detection as Device
- Audio Adapter Accessory Mode
- Debug Accessory Mode
- Active Cable Detection
- Integrates CCx to VCONN Switch with Over-current Limiting for
Powering USB3.1 Full Featured Cables
- USB Power Delivery (PD) 2.0, Version 1.2 Support:
- Automatic Good CRC Packet Response
- Automatic Retries of Sending a Packet if a Good CRC is Not
Received
- Automatic Soft Reset Packet Sent with Retries if Needed
- Automatic Hard Reset Ordered Set Sent
- Dead Battery Support (SNK Mode Support when No Power Applied)
- Low Power Operation: ICC = 25 m A (Typical)
- AEC- Q100 Automotive Qualified Temperature Grade 2:
(- 40°C to +105°C)
- Packaged in:
- 9-ball WLCSP (1.215 mm × 1.260 mm)
- 14-lead MLP (2.5 mm × 2.5 mm, 0.5 mm Pitch)
WLCSP9 CASE 567TN
WQFN14 CASE 510BR
ORDERING INFORMATION
See detailed ordering and shipping information on page 2 of this data sheet.
Applications
- Smartphones
- Tablets
-...
