CS5208−1
MAXIMUM RATINGS*
Parameter
Input Voltage
Operating Junction Temperature Range
Storage Temperature Range
Lead Temperature Soldering:
ESD Damage Threshold
1. 10 second maximum.
*The maximum package power dissipation must be observed.
Wave Solder (through hole styles only) Note 1
Value
6.0
0 ≤ TJ ≤ 150
−60 to +150
260 Peak
2.0
Unit
V
°C
°C
°C
kV
ELECTRICAL CHARACTERISTICS ( 0°C ≤ TA ≤ 70°C, 0°C ≤ TJ ≤ 150°C, VAdj = 0 V, unless otherwise specified.)
Characteristic
Test Conditions
Min Typ Max
Unit
Adjustable Output Voltage
Reference Voltage
Line Regulation
Load Regulation
Minimum Load Current (Note 2)
Adjust Pin Current
Current Limit
Short Circuit Current
Ripple Rejection (Note 3)
VIN = 2.75 V to 5.5 V,
IOUT = 10 mA to 8.0 A
VIN = 2.75 V to 5.5 V, IOUT = 10 mA
VIN = 2.75 V, IOUT = 10 mA to 8.0 A
VIN = 5.0 V, ΔVOUT = +1.5%
VIN = 2.75 V, IOUT = 10 mA
VIN = 2.75 V, ΔVOUT = −1.5%
VIN = 2.75 V, VOUT = 0 V
VIN = 3.25 V Avg, VRIPPLE = 1.0 VP−P @ 120 Hz,
IOUT = 4.0 A, CAdj = 0.1 μF; COUT = 22 μF
1.234
(−1.5%)
−
−
−
−
8.1
6.0
60
1.253
0.02
0.04
5.0
70
9.0
8.5
80
1.271
(+1.5%)
0.20
0.50
10
120
−
−
−
V
%
%
mA
μA
A
A
dB
Thermal Regulation (Note 3)
Dropout Voltage (Minimum VIN−VOUT)
(Note 4)
30 ms Pulse, TA = 25°C
IOUT = 100 mA
IOUT = 1.0 A
IOUT = 2.75 A
IOUT = 4.0 A
IOUT = 8.0 A
− 0.002 − %/W
−
0.92 1.15
V
−
0.93 1.15
V
−
0.94 1.15
V
−
0.95 1.15
V
−
0.96 1.30
V
RMS Output Noise
Temperature Stability
Freq = 10 Hz to 10 kHz, TA = 25°C
−
− 0.003 − %VOUT
− 0.5 − %
Thermal Shutdown (Note 5)
− 150 180 210 °C
Thermal Shutdown Hysteresis (Note 5)
−
− 25 − °C
2. The minimum load current is the minimum current required to maintain regulation. Normally the current in the resistor divider used to set the
output voltage is selected to meet the minimum load current requirement.
3. This parameter is guaranteed by design and is not 100% production tested.
4. Dropout voltage is defined as the minimum input/output voltage differential required to maintain 1.5% regulation.
5. This parameter is guaranteed by design, but not parametrically tested in production. However, a 100% thermal shutdown functional test is
performed on each part.
http://onsemi.com
2