Datasheet4U Logo Datasheet4U.com

LM3000 - Dual Synchronous Emulated Current Mode Controller

General Description

The LM3000 is a dual output synchronous buck controller which is designed to convert input voltages ranging from 3.3V to 18.5V down to output voltages as low as 0.6V.

Key Features

  • which include input under-voltage lock-out (UVLO), power good (PGOOD) signals for each output, over-voltage crowbar and hiccup mode during short circuit events. Features.
  • VIN range from 3.3V to 18.5V Output voltage from 0.6V to 80% of VIN Remote differential output voltage sensing 1% accuracy at FB pin Interleaved operation reduces input capacitors Frequency sync/adjust from 200 kHz to 1.5 MHz Startup with pre-bias load Independent powe.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
LM3000 Dual Synchronous Emulated Current-Mode Controller Texas Instruments

Other Datasheets by National Semiconductor (now Texas Instruments)

Part Number Description
LM300 Voltage Regulator
LM3001 Primary Side PWM Driver
LM301 Operational Amplifiers
LM301A Operational Amplifiers
LM302 LM102/LM302 Voltage Followers
LM3028 Differential RF/IF Amplifier
LM304 Negative Regulator
LM3045 Transistor Arrays
LM3046 Transistor Arrays
LM305 Voltage Regulators

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
LM3000 Dual Synchronous Emulated Current-Mode Controller www.DataSheet4U.com July 2, 2009 LM3000 Dual Synchronous Emulated Current-Mode Controller General Description The LM3000 is a dual output synchronous buck controller which is designed to convert input voltages ranging from 3.3V to 18.5V down to output voltages as low as 0.6V. The two outputs switch at a constant programmable frequency of 200 kHz to 1.5 MHz, with the second output 180 degrees out of phase from the first to minimize the input filter requirements. The switching frequency can also be phase locked to an external frequency. A CLKOUT provides an external clock 90 degrees out of phase with the main clock so that a second chip can be run out of phase with the main chip.