Datasheet4U Logo Datasheet4U.com

PCA9541A - 2-to-1 I2C-bus master selector

Description

The PCA9541A is a 2-to-1 I2C-bus master selector designed for high reliability dual master I2C-bus applications where system operation is required, even when one master fails or the controller card is removed for maintenance.

Features

  • 2-to-1 bidirectional master selector.
  • I2C-bus interface logic; compatible with SMBus standards.
  • PCA9541A/01 powers up with Channel 0 selected.
  • PCA9541A/03 powers up with no channel selected and either master can take control of the bus.
  • Active LOW interrupt input.
  • 2 active LOW interrupt outputs.
  • Active LOW reset input.
  • 4 address pins allowing up to 16 devices on the I2C-bus.
  • Channel selection via I2C-bus.
  • Bus initialization/recovery function.

📥 Download Datasheet

Datasheet Details

Part number PCA9541A
Manufacturer NXP Semiconductors
File Size 390.17 KB
Description 2-to-1 I2C-bus master selector
Datasheet download datasheet PCA9541A Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
PCA9540 2-channel I2C multiplexer NXP
PCA9540B 2-channel I2C-bus multiplexer NXP
PCA9542 2-channel I2C multiplexer and interrupt controller NXP
PCA9543 2-channel I2C switch NXP
PCA9543A 2-Channel I2C Bus Switch Texas Instruments

Other Datasheets by NXP Semiconductors

Part Number Description
PCA9541 2-to-1 I2C-bus master selector
PCA9542A 2-channel I2C-bus multiplexer and interrupt logic
PCA9543A 2-channel I2C-bus switch
PCA9543B 2-channel I2C-bus switch
PCA9543C 2-channel I2C-bus switch

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
PCA9541A 2-to-1 I2C-bus master selector with interrupt logic and reset Rev. 5 — 24 April 2014 Product data sheet 1. General description The PCA9541A is a 2-to-1 I2C-bus master selector designed for high reliability dual master I2C-bus applications where system operation is required, even when one master fails or the controller card is removed for maintenance. The two masters (for example, primary and back-up) are located on separate I2C-buses that connect to the same downstream I2C-bus slave devices. I2C-bus commands are sent by either I2C-bus master and are used to select one master at a time. Either master at any time can gain control of the slave devices if the other master is disabled or removed from the system.
Published: |