TDA8037 Datasheet | NXP Semiconductors

description The TDA8037 is the cost efficient successor of the established integrated contact smart card reader IC TDA8035. It offers a high level of security for the card performing current limitation, short circuit detection, ESD protection as well as supply supervision. Operating in 3 V supply domain, the current consumption during the shutdown mode of the contact reader is very low. It is therefore the ideal ponent for a power efficient contact reader. 2. Features and benefits 2.1 Protection of the contact smart card - Thermal and short-circuit protection on all card contacts - VCC regulation: - 3 V  5 % on 2  220 n F multilayer ceramic capacitors with low ESR - Current spikes of 40 n A up to 20 MHz, with controlled rise and fall times, filtered overload detection approximately 120 m A - Automatic activation and deactivation sequences initiated by software or by hardware in the event of a short-circuit, card take-off, overheating, VDDhost, VREG and VDD dropping - Enhanced card-side Electro Static Discharge (ESD) protection of (> 8 k V) - Supply supervisor for killing spikes during power on and off: - threshold internally fixed - externally by a resistor bridge (with SO28 package only) 2.2 Easy integration into your contact reader - SW patible to TDA8024, TDA8034 and TDA8035 - 3 V smart card supply - Three protected half-duplex bidirectional buffered I/O lines (C4, C7 and C8) - External clock input up to 20 MHz - Card clock generation up to 20 MHz using pin CLKDIV with synchronous frequency changes of f CLKIN, f CLKIN/2 (with SO28 package only) - Non-inverted control of pin RST using pin RSTIN - Built-in debouncing on card presence contact - Multiplexed status signal using pin OFFN - Chip Select digital input for parallel operation of several TDA8037 ICs (with SO28 package only) NXP Semiconductors Low power 3V smart card interface Other - TSSOP16 and SO28 package - SO28 version is footprint patible with TDA8024T - pliant with ISO 7816, Cisco...