PCD3316 Datasheet | NXP Semiconductors

scription The PCD3316 is a low power mixed signal CMOS integrated circuit for receiving physical layer signals like Bellcore’s ‘CPE1 Alerting Signal (CAS)’ and the signals used in similar services. The device is capable of a very high precision detection of the dual tone (2130 and 2750 Hz) by using a patented digital algorithm. The PCD3316 can be used for on-hook and off-hook Caller-ID (CID), Caller-ID on Call Waiting (CIDCW) and Caller-Name (CNAM) applications. For timing purposes the PCD3316 can be programmed to generate an interrupt signal to the microcontroller every second or every minute. These timings are derived from an on-chip 32.768 k Hz oscillator. Also incorporated in the device are a Frequency Shift Keying (FSK) receiver/demodulator and a ‘Ring or polarity change detector’. The status of the PCD3316, the received FSK data bytes and the ringer period can be read and many options can be selected via the I2C-bus serial interface. Two on-chip oscillators are available. One 3.58 MHz oscillator for all internal functions and a low frequency 32.768 k Hz oscillator for the 1 second or 1 minute timing. In Power-down mode only the polarity parators and the 32.768 k Hz oscillator are active. The CAS detection, the FSK receiver and the 3.58 MHz oscillator can be enabled separately. Detection of a polarity change on the inputs POL0 or POL1, the reception of an FSK data byte, the detection of a CAS tone or a timebase interrupt is signalled to the microcontroller by an interrupt request signal (IRQ). The microcontroller can municate with the PCD3316 device via the serial interface. U c c nr 1. CPE = Customer Premises Equipment. es The PCD3316 is designed for use in a microcontroller controlled system. The device is available in a SO16 package. A demonstration board OM5843 and an application note AN98071 are available. tri ct ed Philips Semiconductors CIDCW receiver 2. Features s Bellcore’s ‘CPE Alerting Signal (CAS)’ and British Tele’s (BT) ‘Loop...