P3S0200
P3S0200 is I3C switch manufactured by NXP Semiconductors.
description
The P3S0200 is ideally suited for the switching of high-speed I3C signals in munication and server applications, such as servers, workstations, and notebooks that have limited I3C I/Os. The wide bandwidth (52 MHz) of this switch allows signal to pass with minimum edge and phase distortion. The device multiplexes differential outputs from the I3C controller to one of two corresponding targets with hardware select pin. The switch is bidirectional and offers little or no attenuation of the high-speed signals at the outputs. It is designed for low bit-to-bit skew and high channel-to-channel noise isolation.
2 Features and benefits
- Wide supply voltage range from 2.3 V to 3.6 V
- Switch voltage accepts signals up to 5.5 V
- 1.8 V control logic at VCC = 3.6 V
- Low-power mode when OE is HIGH (2 μA maximum)
- 6 Ω (maximum) ON resistance
- 0.1 Ω (typical) ON resistance mismatch between channels
- 6 p F (typical) ON-state capacitance
- High bandwidth (52 MHz typical)
- Latch-up performance exceeds 100 m A per JESD 78B Class II Level A
- ESD protection:
- HBM JESD22-A114F Class 3A exceeds 8000 V
- CDM JESD22-C101E exceeds 1000 V
- HBM exceeds 12000 V for I/O to GND protection
- Specified from -40 °C to +85 °C
3 Applications
- I3C or I2C 2:1 or 1:2 mux with hardware select pin allowing bus voltage up to 5.5 V
4 Ordering information
Table 1. Ordering information
Type number
Topside marking [1]
Package Name
P3S0200GM x00
XQFN10
Description plastic extremely thin quad flat package; no leads; 10 terminals; body 2 × 1.55 × 0.5 mm
[1] The pin 1 indicator is located on the lower left corner of the device, below the marking code.
Version SOT1049-3
NXP Semiconductors
I3C switch with hardware select and enable
4.1 Ordering options
Table 2. Ordering options
Type number
Orderable part number
P3S0200GM
P3S0200GMX
Package Packing method [1] XQFN10 REEL 7" Q1 NDP
Minimum order...
