Datasheet4U Logo Datasheet4U.com

NX2411 - THREE-PHASE PWM CONTROLLER

Description

The NX2411 is a three-phase PWM controller with integrated FET driver designed to provide a low cost high current multiphase converter that meets the VRD10.0 specification.

Features

  • Differential inductor DCR sensing eliminates the problem with layout parasitic External programmable voltage droop VRM 9 and 10 compatible 6 bit VID On the Fly DAC changes allows smooth transition Internal Digital Soft Start Low Impedance On-board Drivers Power Good Signal for Power Sequencing Over voltage protection with latch function Enable Signal allows external shutdown as well as programming the BUS voltage start up threshold.

📥 Download Datasheet

Datasheet Details

Part number NX2411
Manufacturer NEXSEM
File Size 26.84 KB
Description THREE-PHASE PWM CONTROLLER
Datasheet download datasheet NX2411 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
NX2415 DOT MATRIX PRINTER MANUAL star
NX2415II DOT MATRIX PRINTER MANUAL star
NX2422 TWO PHASE SYNCHRONOUS PWM CONTROLLER Microsemi
NX2016SF Crystal Units NDK
NX2020N2 N-channel Trench MOSFET NXP

Other Datasheets by NEXSEM

Part Number Description
NX2415 TWO PHASE SYNCHRONOUS PWM CONTROLLER
NX2114 300kHz & 600kHz SYNCHRONOUS PWM CONTROLLER
NX2114A 300kHz & 600kHz SYNCHRONOUS PWM CONTROLLER
NX2120 SYNCHRONOUS PWM CONTROLLER
NX2150 SINGLE POWER SUPPLY SYNCHRONOUS PWM CONTROLLER

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
Evaluation board available. NEXSEM NX2411 THREE-PHASE PWM CONTROLLER WITH INTEGRATED FET DRIVER AND DIFFERENTIAL CURRENT SENSING FOR VRD10.X DESCRIPTION The NX2411 is a three-phase PWM controller with integrated FET driver designed to provide a low cost high current multiphase converter that meets the VRD10.0 specification. Multiphase synchronous buck converter offers ripple cancelation for both input and output.The NX2411 uses differential remote sensing using either current sense resistor or inductor DCR sensing to achieve accurate current matching between the three channels. Differential sensing eliminates the error caused by PCB board trace resistance that is otherwise present when using a single ended voltage sensing.
Published: |