UPC29M08HF Datasheet | NEC

ture the ability to source 0.5 A of output current with a low dropout voltage of typically 0.5 V. The power dissipation of the µ PC29M00 series can be drastically reduced pared with the conventional three terminal positive voltage regulators that is constructed with NPN output transistor. Also, this series corresponds to the low voltage output (3 V, 3.3 V) which is not in the conventional low dropout regulators (µ PC24M00A series). Features - Output current in excess of 0.5 A - Low dropout voltage VDIF = 0.5 V TYP. (at I O = 0.5 A) - On-chip overcurrent and thermal protection circuit - On-chip output transistor safe area protection circuit PIN CONFIGURATION (Marking Side) µPC29M00HF Series: MP-45G µPC29M00HB Series: MP-3 µPC29M00T Series: MP-3Z 3 1: INPUT 2: GND 3: OUTPUT 1: 2: 3: 4: INPUT GND OUTPUT GND (Fin) The information in this document is subject to change without notice. Document No. G10027EJ3V0DS00 (3rd edition) Date Published July 1998 N CP(K) Printed in Japan The mark shows major revised points. © µPC29M00 Series BLOCK DIAGRAM INPUT Safe operating area protection Start-up circuit Reference voltage Error amp. Drive circuit Saturation protection OUTPUT Thermal shut down Over current protection GND ORDERING INFORMATION Part Number Package MP-45G (Isolated TO-220) MP-3 (SC-64) MP-3Z (SC-63) MP-45 (Isolated TO-220) MP-3 (SC-64) MP-3Z (SC-63) MP-45G (Isolated TO-220) MP-3 (SC-64) MP-3Z (SC-63) MP-45G (Isolated TO-220) MP-3 (SC-64) MP-3Z (SC-63) MP-45G (Isolated TO-220) MP-3 (SC-64) MP-3Z (SC-63) MP-45G (Isolated TO-220) MP-3 (SC-64) MP-3Z (SC-63) MP-45G (Isolated TO-220) MP-3 (SC-64) MP-3Z (SC-63) MP-45G (Isolated TO-220) MP-3 (SC-64) MP3Z (SC-63) MP-45G (Isolated TO-220) MP-3 (SC-64) MP-3Z (SC-63) Output Voltage 3.0 V 3.0 V 3.0 V 3.3 V 3.3 V 3.3 V 5.0 V 5.0 V 5.0 V 6.0 V 6.0 V 6.0 V 7.0 V 7.0 V 7.0 V 8.0 V 8.0 V 8.0 V 9.0 V 9.0 V 9.0 V 10.0 V 10.0 V 10.0 V 12.0 V 12.0 V 12.0 V µ PC29M03HF µ PC29M03HB µ PC29M03T µ...