P6SMB27A Datasheet | Multicomp

Features : - For surface mounted application in order to optimize board space. - Low profile package. - Built-in strain relief. - Glass passivated junction. - Excellent clamping capability. - Fast response time: typically less than 1.0ps from 0 volt to BV minimum. - Typical IR less than 1µA above 10V. - High temperature soldering guaranteed: 260°C/10 seconds at terminals. - Plastic material used carries. - 600 watts peak pulse power capability with a 10 x 1000µs waveform by 0.01% duty cycle. SMB/DO-214AA Dimensions : Inches (Millimetres) Mechanical Data Case Terminals Polarity Standard packaging Weight : Molded plastic : Pure tin plated lead free. : Indicated by cathode band. : 12mm tape (EIA STD RS-481). : 0.093 gram. Maximum Ratings and Electrical Characteristics Rating at 25°C ambient temperature unless otherwise specified. Page <1> 19/05/08 V1.1 P6SMB Series Type Number Peak Power Dissipation at TA = 25°C, Tp = 1ms (Note 1) Steady State Power Dissipation Peak Forward Surge Current, 8.3ms Single Half Sine-wave Superimposed on Rated Load (JEDEC method) (Note 2, 3) - Unidirectional Only Maximum Instantaneous Forward Voltage at 50.0A for Unidirectional Only (Note 4) Typical Thermal Resistance (Note 5) Operating and Storage Temperature Range Symbol PPK PD IFSM VF RθJC RθJA TJ, TSTG Value Minimum 600 3.5/5.0 10 55 -65 to + 150 Notes: 1. Non-repetitive current pulse and derated above TA = 25°C. 2. Mounted on 5.0mm2 (0.013mm thick) copper pads to each terminal. 3. 8.3ms single half sine-wave or equivalent square wave, duty cycle = 4 pulses per minutes maximum. 4. VF = 3.5V on P6SMB6.8 thru P6SMB91 devices and VF = 5.0V on P6SMB100 thru P6SMB220 devices. 5. Measured on P.C.B. with 0.27 x 0.27 Inch (7.0 x 7.0mm) copper pad areas. Devices for bipolar applications 1. For bidirectional use C or CA suffix for types P6SMB6.8 through types P6SMB220A. 2. Electrical characteristics apply in both directions. Units Watts Amps Volts...