Datasheet4U Logo Datasheet4U.com

MC145200 - 2.0 GHz PLL Frequency Synthesizers

Description

section.

MC145201 2 MOTOROLA ELECTRICAL CHARACTERISTICS (VDD = VCC = 4.5 to 5.5 V, Voltages Referenced to GND, TA = 40 to + 85°C, unless otherwise stated; MC145200: VPD = 8.0 to 9.5 V; MC145201: VPD = 4.5 to 5.5 V with VDD ≤ VPD.) Symbol VIL VIH Vhys VOL VOH IOL IOH IO

Features

  • a single.
  • ended current source/sink phase detector output and a double.
  • ended phase detector output. Both phase detectors have linear transfer functions (no dead zones). The maximum current of the single.
  • ended phase detector output is determined by an external resistor tied from the Rx pin to ground. This current can be varied via the serial port. The MC145200 features logic.
  • level converters and high.
  • voltage phase/ frequency detectors; the detector supply ma.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
MC14520B Dual Up Counters ON Semiconductor
MC14521B 24-Stage Frequency Divider ON Semiconductor
MC14526B Presettable 4-Bit Down Counters ON Semiconductor
MC14528B Dual Monostable Multivibrator ON Semiconductor
MC145010 Photoelectric Smoke Detector IC Freescale Semiconductor

Other Datasheets by Motorola Semiconductor (now NXP Semiconductors)

Part Number Description
MC145201 2.0 GHz PLL Frequency Synthesizers
MC145202 Low-Voltage 2.0 GHz PLL Frequency Synthesizer
MC14520B DUAL UP COUNTERS
MC14521B 24-Stage Frequency Divider
MC145220 Dual 1.1 GHz PLL Frequency Synthesizer

Full PDF Text Transcription

Click to expand full text
MOTOROLA SEMICONDUCTOR TECHNICAL DATA Order this document by MC145200/D 2.0 GHz PLL Frequency Synthesizers MC145200 MC145201 Include On–Board 64/65 Prescalers The MC145200 and MC145201 are single–package synthesizers with serial interfaces capable of direct usage up to 2.0 GHz. A special architecture makes these PLLs very easy to program because a byte–oriented format is utilized. Due to the patented BitGrabber™ registers, no address/steering bits are required for random access of the three registers. Thus, tuning can be accomplished via a 3–byte serial transfer to the 24–bit A register. The interface is both SPI and MICROWIRE™ compatible. Each device features a single–ended current source/sink phase detector output and a double–ended phase detector output.
Published: |