SST26VF016BA Datasheet | Microchip Technology

Features - Single Voltage Read and Write Operations - 2.7-3.6V - Serial Interface Architecture - Nibble-wide multiplexed I/O’s with SPI-like serial mand structure - Mode 0 and Mode 3 - x1/x2/x4 Serial Peripheral Interface (SPI) Protocol - High Speed Clock Frequency - 104 MHz max - Burst Modes - Continuous linear burst - 8/16/32/64 Byte linear burst with wrap-around - Superior Reliability - Endurance: 100,000 Cycles (min) - Greater than 100 years Data Retention - Low Power Consumption: - Active Read current: 15 m A (typical @ 104 MHz) - Standby Current: 15 μA (typical) - Fast Erase Time - Sector/Block Erase: 18 ms (typ), 25 ms (max) - Chip Erase: 35 ms (typ), 50 ms (max) - Page-Program - 256 Bytes per page in x1 or x4 mode - End-of-Write Detection - Software polling the BUSY bit in status register - Flexible Erase Capability - Uniform 4 KByte sectors - Four 8 KByte top and bottom parameter overlay blocks - One 32 KByte top and bottom overlay blocks - Uniform 64 KByte overlay blocks - Write-Suspend - Suspend Program or Erase operation to access another block/sector - Software Reset (RST) mode - Software Write Protection - Individual-Block Write Protection with permanent lock-down capability - 64 KByte blocks, two 32 KByte blocks, and eight 8 KByte parameter blocks - Read Protection on top and bottom 8 KByte parameter blocks - Security ID - One-Time Programmable (OTP) 2 KByte, Secure ID - 64 bit unique, factory pre-programmed...