PIC24FJ16MC101/102 AND
PIC24FJ32MC101/102/104
16-Bit Microcontrollers
(up to 32-Kbyte Flash and 2-Kbyte SRAM)
Operating Conditions
• 3.0V to 3.6V, -40ºC to +125ºC, DC to 16 MIPS
Core: 16-Bit PIC24F CPU
• Code-Efficient (C and Assembly) Architecture
• Two 40-Bit Wide Accumulators
• Single-Cycle (MAC/MPY) with Dual Data Fetch
• Single-Cycle Mixed-Sign MUL plus Hardware Divide
• 32-Bit Multiply Support
Clock Management
• ±0.25% Internal Oscillator
• Programmable PLLs and Oscillator Clock Sources
• Fail-Safe Clock Monitor (FSCM)
• Independent Watchdog Timer (WDT)
• Fast Wake-up and Start-up
Power Management
• Low-Power Management modes (Sleep, Idle, Doze)
• Integrated Power-on Reset and Brown-out Reset
• 1 mA/MHz Dynamic Current (typical)
• 30 µA IPD Current (typical)
PWM
• Up to Three PWM Pairs
• Two Dead-Time Generators
• 31.25 ns PWM Resolution
• PWM Support for:
- Inverters, PFC, UPS
- BLDC, PMSM, ACIM, SRM
• Class B Compliant Fault Inputs
• Possibility of ADC Synchronization with PWM Signal
Advanced Analog Features
• ADC module:
- 10-bit, 1.1 Msps with four S&H
- Six analog inputs on 20-pin devices, eight analog
inputs on 28-pin devices and up to 16 analog inputs
on 44-pin devices
• Flexible and Independent ADC Trigger Sources
• Three Comparator modules
• Charge Time Measurement Unit (CTMU):
- Supports mTouch™ capacitive touch sensing
- Provides high-resolution time measurement (1 ns)
- On-chip temperature measurement
Timers/Output Compare/Input Capture
• Five General Purpose Timers:
- One 16-bit and two 32-bit timers/counters
• Two Output Compare modules
• Three Input Capture modules
• Peripheral Pin Select (PPS) to allow Function Remap
Communication Interfaces
• UART module (4 Mbps):
- With support for LIN/J2602 protocols and IrDA®
• 4-Wire SPI module (8 MHz maximum speed):
- Remappable pins in 32-Kbyte Flash devices
• I2C™ module (400 kHz)
Input/Output
• Sink/Source 10 mA or 6 mA, Pin-Specific for Standard
VOH/VOL, up to 16 mA or 12 mA for Non-Standard VOH1
• 5V Tolerant Pins
• Up to 21 Open-Drain, Pull-ups and Pull-Downs
• External Interrupts on most I/O Pins
Qualification and Class B Support
• AEC-Q100 REV G (Grade 0, -40ºC to +125ºC) Planned
• Class B Safety Library, IEC 60730, UDE Certified
Debugger Development Support
• In-Circuit and In-Application Programming
• Up to Three Complex Data Breakpoints
• Trace and Run-Time Watch
2011-2014 Microchip Technology Inc.
DS30009997E-page 1
