PIC18F26K80 Datasheet | Microchip Technology

Features : - Conforms to CAN 2.0B Active Specification - Three Operating modes: - Legacy mode (full backward patibility with existing PIC18CXX8/FXX8 CAN modules) - Enhanced mode - FIFO mode or programmable TX/RX buffers - Message Bit Rates up to 1 Mbps - Device Net™ Data Byte Filter Support - Six Programmable Receive/Transmit Buffers - Three Dedicated Transmit Buffers with Prioritization - Two Dedicated Receive Buffers TABLE 1: DEVICE PARISON ECAN Bus Module Features (Continued): - 16 Full, 29-Bit Acceptance Filters with Dynamic Association - Three Full, 29-Bit Acceptance Masks - Automatic Remote Frame Handling - Advanced Error Management Features Special Microcontroller Features : - Operating Voltage Range: 1.8V to 5.5V - On-Chip 3.3V Regulator - Operating Speed up to 64 MHz - Up to 64 Kbytes On-Chip Flash Program Memory: - 10,000 erase/write cycle, typical - 20 years minimum retention, typical - 1,024 Bytes of Data EEPROM: - 100,000 Erase/write cycle data EEPROM memory, typical - 3.6 Kbytes of General Purpose Registers (SRAM) - Three Internal Oscillators: LF-INTOSC (31 KHz), MF-INTOSC (500 k Hz) and HF-INTOSC (16 MHz) - Self-Programmable under Software Control - Priority Levels for Interrupts - 8 x 8 Single-Cycle Hardware Multiplier - Extended Watchdog Timer (WDT): - Programmable period from 4 ms to 4,194s - In-Circuit Serial Programming™ (ICSP™) via Two Pins - In-Circuit Debug via Two Pins - Programmable...