PIC18F24/25Q10
• Direct, Indirect and Relative Addressing modes
Operating Characteristics
• Operating Voltage Range:
– 1.8V to 5.5V
• Temperature Range:
– Industrial: -40°C to 85°C
– Extended: -40°C to 125°C
Power-Saving Operation Modes
• Doze: CPU and Peripherals Running at Different Cycle Rates (typically CPU is lower)
• Idle: CPU Halted While Peripherals Operate
• Sleep: Lowest Power Consumption
• Peripheral Module Disable (PMD):
– Ability to selectively disable hardware module to minimize active power consumption of unused
peripherals
• Extreme Low-Power mode (XLP)
– Sleep: 500 nA typical @ 1.8V
– Sleep and Watchdog Timer: 900 nA typical @ 1.8V
Digital Peripherals
• Complementary Waveform Generator (CWG):
– Rising and falling edge dead-band control
– Full-bridge, half-bridge, 1-channel drive
– Multiple signal sources
• Capture/Compare/PWM (CCP) modules:
– Two CCPs
– 16-bit resolution for Capture/Compare modes
– 10-bit resolution for PWM mode
• 10-Bit Pulse-Width Modulators (PWM):
– Two 10-bit PWMs
• Serial Communications:
– One Enhanced USART (EUSART) with Auto-Baud Detect, Auto-wake-up on Start.
RS-232, RS-485, LIN compatible
– SPI
– I2C, SMBus and PMBus™ compatible
• Up to 25 I/O Pins and One Input Pin:
– Individually programmable pull-ups
– Slew rate control
– Interrupt-on-change on all pins
– Input level selection control
• Programmable CRC with Memory Scan:
© 2018 Microchip Technology Inc.
Datasheet Preliminary
DS40001945B-page 2
