Datasheet4U Logo Datasheet4U.com

LAN9254 - SubDevice Controller

Description

8 3.0 Pin Descriptions and Configuration 12 4.0 Power Connections

Features

  • - 3 power-down levels - Wake on link status change (energy detect) - Magic packet wakeup, Wake on LAN (WoL), wake on broadcast, wake on perfect DA - Wakeup indicator event signal.
  • Power and I/O - Integrated power-on reset circuit - Latch-up performance exceeds 150mA per EIA/JESD78, Class II - JEDEC Class 3A ESD performance - Single 3.3V power supply (integrated 1.2V regulator).
  • Additional Features - EEPROM emulation - Transformer-less link support - Multifunction GPIOs - Abilit.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
LAN9210 Small Form Factor Single-Chip Ethernet Controller SMSC Corporation
LAN9215 Highly Efficient 10/100 Ethernet Controller SMSC Corporation
LAN9215I Highly Efficient Single-Chip 10/100 Ethernet Controller SMSC Corporation
LAN9217 16-bit High-Performance Single-Chip 10/100 Ethernet Controller SMSC Corporation
LAN9218 High-Performance Single- Chip 10/100 Ethernet Controller SMSC Corporation

Other Datasheets by Microchip

Part Number Description
LAN9250 10/100 Industrial Ethernet Controller
LAN9252 2/3-Port EtherCAT Slave Controller
LAN9253 SubDevice Controller
LAN9255 2/3-Port EtherCAT Controller
LAN9115 Highly Efficient Single-Chip 10/100 Non-PCI Ethernet Controller

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
LAN9254 2/3-Port EtherCAT® SubDevice Controller with Integrated Ethernet PHYs and Demultiplexed HBI / 32 DIGIOs Highlights • 2/3-port EtherCAT SubDevice controller with 8 Fieldbus Memory Management Units (FMMUs) and 8 SyncManagers • Interfaces to most 8/16-bit embedded controllers and 32-bit embedded controllers with an 8/16-bit bus • Integrated Ethernet PHYs with HP Auto-MDIX • Wake on LAN (WoL) support • Low power mode allows systems to enter sleep mode until addressed by the MainDevice • Cable diagnostic support • 1.8V to 3.3V variable voltage I/O • Integrated 1.2V regulator for single 3.
Published: |