Datasheet4U Logo Datasheet4U.com

MIC826 - Voltage Supervisor

General Description

The MIC826 is a low-current, ultra-small, voltage supervisor with manual reset input, watchdog timer, and active-high and active-low push-pull outputs.

Key Features

  • an integrated pull-up resistor on the /MR. An active-low push-pull reset output (/RESET) and an active-high reset output (RESET) provide flexibility when interfacing with various microcontrollers, PMICs, or load switches. The watchdog input can be left unconnected for.

📥 Download Datasheet

Datasheet Details

Part number MIC826
Manufacturer Micrel Semiconductor
File Size 490.65 KB
Description Voltage Supervisor
Datasheet download datasheet MIC826 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
MIC826 Voltage Supervisor Microchip
MIC841 Comparator Microchip
MIC842 Comparator Microchip
MIC862 Dual Ultra-Low Power Op Amp Microchip
MIC863 Dual Ultra-Low Power Op Amp Microchip

Other Datasheets by Micrel Semiconductor

Part Number Description
MIC820 Teeny Ultra Low Power Op Amp
MIC803 3-Pin Microprocessor Supervisor Circuit
MIC8030 High-Voltage Display Driver
MIC809 Microprocessor Reset Circuits
MIC809-5 Microprocessor Reset Circuit

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
MIC826 Voltage Supervisor with Watchdog Timer, Manual Reset, and Dual Outputs In 1.6mm x 1.6mm TDFN General Description The MIC826 is a low-current, ultra-small, voltage supervisor with manual reset input, watchdog timer, and active-high and active-low push-pull outputs. The reset outputs are asserted and held when the supply voltage falls below the factory-programmed threshold voltage, when the /MR pin is pulled low, or if the watchdog times out. Reset is asserted for the reset timeout delay after the supply voltage increases above the rising threshold voltage or when manual reset input is asserted high. The MIC826 features an integrated pull-up resistor on the /MR.