Datasheet4U Logo Datasheet4U.com

MAX9129 - Quad Bus LVDS Driver

General Description

The MAX9129 is a quad bus low-voltage differential signaling (BLVDS) driver with flow-through pinout.

This device is designed to drive a heavily loaded multipoint bus with controlled transition times (1ns 0% to 100% minimum) for reduced reflections.

Key Features

  • MAX9129 Ordering Information PART MAX9129EGE MAX9129EUE TEMP. RANGE -40°C to +85°C -40°C to +85°C PIN-.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
MAX912 Low-Power Precision TTL Comparators Maxim
MAX9120 Beyond-the-Rails Comparators With/Without Reference Maxim Integrated
MAX9124 Quad LVDS Line Driver Maxim
MAX9125 Quad LVDS Line Receivers Maxim
MAX9126 Quad LVDS Line Receivers Maxim Integrated

Other Datasheets by Maxim Integrated (Analog Devices)

Part Number Description
MAX9121 Quad LVDS Line Receivers
MAX9122 Quad LVDS Line Receivers
MAX9123 Quad LVDS Line Driver
MAX910 (MAX910 / MAX911) High SPeed Threshold Programmable Voltage Comparators
MAX911 (MAX910 / MAX911) High SPeed Threshold Programmable Voltage Comparators

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
19-2100; Rev 0; 8/01 Quad Bus LVDS Driver with Flow-Through Pinout General Description The MAX9129 is a quad bus low-voltage differential signaling (BLVDS) driver with flow-through pinout. This device is designed to drive a heavily loaded multipoint bus with controlled transition times (1ns 0% to 100% minimum) for reduced reflections. The MAX9129 accepts four LVTTL/LVCMOS input levels and translates them to output levels of 250mV to 450mV (stanwww.DataSheet4U.com dard LVDS levels) into a 27 Ω load at speeds up to 200Mbps (100MHz). The power-on reset ensures that all four outputs are disabled and high impedance during power up and power down. The outputs can be set to high impedance by two enable inputs, EN and EN, thus dropping the device to a low-power state of 11mW.