Datasheet4U Logo Datasheet4U.com

DS1972 - 1024-Bit EEPROM iButton

General Description

The DS1972 is a 1024-bit, 1-Wire EEPROM organized as four memory pages of 256 bits each in a rugged iButton package.

Data is written to an 8byte scratchpad, verified, and then copied to the EEPROM memory.

Key Features

  • 1024 Bits of EEPROM Memory Partitioned into Four Pages of 256 Bits Individual Memory Pages can be Permanently Write Protected or Put in EPROM-Emulation Mode ("Write to 0") Switchpoint Hysteresis and Filtering to Optimize Performance in the Presence of Noise IEC 1000-4-2 Level 4 ESD Protection (8kV Contact, 15kV Air, typical) Reads and Writes Over a Wide Voltage Range of 2.8V to 5.25V from -40°C to +85°C Communicates to Host with a Single Digital Signal at 15.4.

📥 Download Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
DS1971 256-Bit EEPROM iButton Maxim Integrated
DS1971 256-Bit EEPROM iButton Dallas Semiconducotr
DS1973 4Kb EEPROM iButton Maxim Integrated
DS1973 4-kbit EEPROM iButton Dallas Semiconducotr
DS1976 Shielded Drum Core Inductors Tyco Electronics

Other Datasheets by Maxim Integrated (Analog Devices)

Part Number Description
DS1990R Serial Number IButton
DS1080CL Spread-Spectrum Crystal Multiplier
DS1081L Spread-Spectrum Clock Modulator
DS1085L 3.3V EconOscillator Frequency Synthesizer
DS1088C Fixed-Frequency EconoOscillator

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
www.DataSheet4U.com DS1972 1024-Bit EEPROM iButton www.maxim-ic.com iButton DESCRIPTION The DS1972 is a 1024-bit, 1-Wire EEPROM organized as four memory pages of 256 bits each in a rugged iButton package. Data is written to an 8byte scratchpad, verified, and then copied to the EEPROM memory. As a special feature, the four memory pages can individually be write protected or put in EPROM-emulation mode, where bits can only be changed from a 1 to a 0 state. The DS1972 communicates over the single-conductor 1-Wire bus. The communication follows the standard Dallas Semiconductor 1-Wire protocol. Each device has its own unalterable and unique 64-bit ROM registration number that is factory lasered into the device.