Datasheet4U Logo Datasheet4U.com

MP5002DQ - 1A-3A Programmable Current Limit Switch

Download the MP5002DQ datasheet PDF. This datasheet also covers the MP5002 variant, as both devices belong to the same 1a-3a programmable current limit switch family and are provided as variant models within a single manufacturer datasheet.

Description

The MP5002 is a protection device designed to protect circuitry on the output (VOUT) from transients on the input (VIN).

It also protects VIN from undesired shorts and transients coming from the load.

At start up, inrush current is limited by limiting the slew rate at VOUT.

Features

  • Integrated 44mΩ Power FET.
  • Enable/Fault Pin.
  • Adjustable Slew Rate for Output Voltage.
  • Adjustable Current Limit: 1A-3A.
  • Thermal Protection.
  • Over Voltage Limit.

📥 Download Datasheet

Note: The manufacturer provides a single datasheet file (MP5002-MPS.pdf) that lists specifications for multiple related part numbers.

📁 Similar Datasheet

Part Number Description Manufacturer
MP5005 50 Amp Single Phase Bridge Rectifier Micro Commercial Components
MP5005 PRESS-FIT MOTOLOLA DIODES Shunye
MP5005W Single Phase Bridge Rectifier MCC
MP5006 50 Amp Single Phase Bridge Rectifier Micro Commercial Components
MP5007 50 Amp Single Phase Bridge Rectifier Micro Commercial Components

Other Datasheets by Monolithic Power Systems

Part Number Description
MP5002 1A-3A Programmable Current Limit Switch
MP5000 5A Programmable Current Limit Switch
MP5000A 5A Programmable Current Limit Switch
MP5000ADQ 5A Programmable Current Limit Switch
MP5000DQ 5A Programmable Current Limit Switch

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
The Future of Analog IC Technology MP5002 3.3V, 1A-3A Programmable Current Limit Switch DESCRIPTION The MP5002 is a protection device designed to protect circuitry on the output (VOUT) from transients on the input (VIN). It also protects VIN from undesired shorts and transients coming from the load. At start up, inrush current is limited by limiting the slew rate at VOUT. The slew rate is controlled by a small capacitor at the dv/dt pin. The dv/dt pin has an internal circuit that allows the customer to float this pin (no connect) and still receive a 1.1ms ramp time at VOUT. The max load at the output (VOUT) is current limited. This is accomplished by utilizing a sense FET topology. The magnitude of the current limit is controlled by an external resistor connected between the ILIMIT pins.
Published: |