Transient Voltage Suppressors (TVS) Data Sheet
For surface mounted applications in order to optimize board space
600W peak pulse power capability at 10/1000μs waveform,
repetition rate (duty cycle): 0.01%
Typical IR less than 1μA above 10V
Low profile package
Built-in strain relief
Glass passivated junction
Excellent clamping capability
High Temperature soldering: 260℃/10 seconds at terminals
Fast response time
Plastic package has underwriters laboratory flammability 94V-0
Meets MSL level 1, per J-STD-020
Safety certification: UL: E244458
AEC-Q101 qualified (P6SMBF6.8~P6SMBF170)
Case: SMBF Molded plastic over glass passivated junction
Terminal: Solder plated, solderable per MIL-STD-750, Method 2026
Polarity: Color band denotes cathode except bi-directional models
Standard Packaging: 12mm tape (EIA STD RS-481)
AC/DC power supply
Low frequency signal transmission line (RS232, RS485, etc.)
Maximum Ratings and Characteristics
Ratings at 25℃ ambient temperature unless otherwise specified.
Peak pulse power dissipation at 10/1000μs waveform
(Note1, Note2, Fig.1)
Minimum 600 Watts
Peak pulse current of at 10/1000μs waveform (Note 1, Fig.3)
Steady state power dissipation at TA=50℃ (Fig.5)
Peak forward surge current, 8.3ms single half sine-wave
superimposed on rated load, (JEDEC Method) (Note3, Fig.6)
PM(AV) 5.0 Watts
IFSM 100 Amps
Operating junction and Storage Temperature Range.
-65 to +150
Typical thermal resistance junction to lead
Typical thermal resistance junction to ambient
Notes: 1. Non-repetitive current pulse, per Fig.3 and derated above TA=25℃ per Fig.2.
2. Mounted on 5.0mm×5.0mm (0.03mm thick) copper pads to each terminal.
3. 8.3ms single half sine-wave, or equivalent square wave, duty cycle=4 pulses per minutes maximum.
Page 1 of 4