DF7-3EP-3.96DS Datasheet | Hirose

3.96 mm Pitch Miniature Connectors for Internal Power Supplies (UL,C-UL and TÜV Listed) DF7 Series plete Locking Function pletely enclosed locking system Full barrier between adjacent contacts. Prevention of Incorrect Connections s Features 1. plete Locking Function Reliable interior lock protects mated connectors from accidental disconnection. 2. Increased Contact Retention of Crimped Contacts and Prevention of Inplete Insertion Separate contact retainer increases the contact retention, assures and visually confirms the plete contact insertion. 3. Molded-in Contact Retention Tabs Handling of terminated contacts during the assembly and termination is easier and avoids entangling of wires, since there are no protruding metal tabs. 4. Incorrect Insertion Prevention Connectors are polarized to assure correct mating with corresponding parts. Guide post 5.Solder Crack Prevention Glass reinforced resin is used in the pin header bodies to prevent solder cracks caused by the heat shrinkage. Board Eyelet mounting 6. Prevention of Incorrect Board Placement Built-in locating posts assure correct connector placement and orientation on the board.(2-12 pos.) 7. Supports Sealing after Installation. Sealing pound can be applied to the board installed connector for distance of 6 mm max. from the mounting surface (9 mm max. for single position). 8.Cost Effective Tooling The same crimping tools are used to terminate socket and pin contacts. 9. Prevention of Short Circuits between Adjacent Contacts Each contact is pletely surrounded by the insulator housing, electrically isolating it from adjacent contacts. One pos. type can also be mounted to boards that have eyelets. Continued. 10. 10 A maximum Current Connector can carry current of 10 A per contact with #16 AWG conductor.Refer to page 3 for current ratings for multi-position connectors using other conductor sizes. 12. Supports Eyelets 1 pos. can be mounted to boards which have...