900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf






HRS

CL331-0471-0-10 Datasheet Preview

CL331-0471-0-10 Datasheet

(CL331-0471-0-01) Receptacles

No Preview Available !

SMT Ultra-Miniature Coaxial Connectors - Mating Heights Owing to the Lowest Profile and the Lightest
U.FL Series
Meets up to 6 GHz Requirement
Figure 1. Mating Height Comparison
(with Hirose Electric Products)
U.FL
E.FL
sFeatures
1. Mating Heights Owing to Lowest Profile
Height from the printed circuit board when mates a receptacle with
a (right-angle) plug is 2.5 mm maximum. This low Profile is at the
world’s shortest level.
2. Extremely Small Board Occupation Area
In comparison with our E.FL Series of SMT coaxial connectors, the
receptacles offer a reduction of approximately 18% of the board
occupation area resulting in an area of just 7.7 mm2.
3. World’s Lightest
These are the world’s lightest coaxial connectors.
Receptacle: 15.7 mg
Right-angle plugs
For Ø 0.81 mm cable: 53.7 mg
For Ø 1.13 & 1.32 mm cable: 59.1 mg
4. Can Be Used Up to a Frequency of 6 GHz
To meet the frequency requirements of a wide variety of miniature
equipment, these connectors offer high frequency performance
from DC to 6 GHz.
5. Can Be Used with Automatic Mounting
The embossed tape packaging specification of the receptacles
permits automatic mounting.
6. Use of Ultra-Fine Teflon Cable
From among the types of suitable cable, Ø 0.8 mm (single shield)
outside diameter ultra-fine Teflon coaxial cable has been made a
standard specification in consideration of improving the
construction qualities and construction area.
An external diameter Ø1.32 mm (double shield) & Ø1.13mm (single
shield) ultra-fine Teflon coaxial cable specification is also available.
7. Simple Removal of Connectors
The extraction jig permits simple removal of connectors.
8. Mating Checks Are Easy
Subminiature size notwithstanding, the lock sensation permits a
check of sure mating.
qSpace Factor of Mated Connector
Figure 2. U.FL-LP-040 and U.FL-R-SMT
U.FL-R-SMT
U.FL-LP-040
Figure 3. U.FL-LP-066and U.FL-R-SMT
U.FL-R-SMT
U.FL-LP-066
sApplications
Mobile phones, wireless communications
equipment, electronic measuring instruments,
GPS, wireless LAN, Bluetooth etc.
2002.3
1




HRS

CL331-0471-0-10 Datasheet Preview

CL331-0471-0-10 Datasheet

(CL331-0471-0-01) Receptacles

No Preview Available !

s Product Specifications
Ratings
Nominal characteristic impedance
Rated voltage
Rated frequency
50ø
60 V AC (rms)
DC to 6 GHz
Operating temperature range
Operating humidity
-40˚C to +90˚C
90% max.
Item Specification
1. Contact resistance
Center: 20 mø max.
Outside: 10 mø max.
2. Insulation resistance
3. Withstand voltage
4. V.S.W.R.*
500 Mø min.
No line or insulation breakdown
1.3 max.
Dia.0.81Cable
Dia.1.13Cable
Dia.1.32Cable
5. Female contact holding force 0.15 N min.
1.35
1.4
1.5
6. Repetitive operation
Contact
resistance
25
15
mø
mø
max.
max.
(Center)
(Outside)
7. Vibration
No momentary disconnections of 1 µs min.
No damage, cracks, or parts looseness min.
Conditions
Measured at 10 mA max.
Measured at 100 V DC
200 V AC for 1 minute
DC to 3 GHz
3 to 6 GHz
Measured with a Ø 0.475 pin gauge
30 cycles of insertion and disengagement
Frequency of 10 to 100 Hz, single amplitude of 1.5 mm,
acceleration of 59 m/s2, for 5 cyles in the direction of each of the 3 axes
8. Shock
No momentary disconnections of 1 µs min.
No damage, cracks, or parts looseness
Acceleration of 735 m/s2, 11 ms duration, sine half-wave
waveform, for 6 cycles in the direction of each of the 3 axes
9. Humidity resistance
9. (Steady state)
No damage, cracks, or parts looseness
Insulation resistance 100 Mø min.(High temperature)
Insulation resistance 500 Mø min.(Pry)
Temperature of 40˚C, humidity of 95%,
let stand for 96 hours
10. Temperature cycle
No damage, cracks, or parts looseness
Contact resistance 25 mø max. (Center)
15 mø max. (Outside)
Temperature: +40˚C / 5 to 35˚C / +90˚C / 5 to 35˚C
Time:
30 min. / Within 5 min. / 30 min. / Within 5 min.
Cycles: 5
11. Salt spray test
No excessive corrosion
48 hours continuous exposure to 5% salt water
*V.S.W.R. Measurement System
The above V.S.W.R. standard values were measured using the measurement system of the diagram below.
NOTE 1: Cable type connectors were measured with SMA conversion adapters
attached to both ends of the harness product of a suitable 100cm cable.
NOTE 2: Board type connectors were mounted to a 50glass epoxy board and
measurements were conducted with SMA conversion adapters attached.
sMaterials
Part
Shell
Male center contact
Female center contact
Insulator
Material
Phosphor bronze
Brass
Phosphor bronze
Plug
PBT
Receptacle
LCP
Finish
Silver plating
Gold plating
Gold plating
Black
Beige
Remarks
—————
—————
—————
UL94V-0
UL94V-0
2


Part Number CL331-0471-0-10
Description (CL331-0471-0-01) Receptacles
Maker HRS
PDF Download

CL331-0471-0-10 Datasheet PDF






Similar Datasheet

1 CL331-0471-0-10 (CL331-0471-0-01) Receptacles
HRS





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z



Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy