FT4232HQ Datasheet | FTDI

ures 4 UARTs. Two of these have an option to independently configure - an MPSSE engine. This allows the FT4232H to operate as two UART/Bit-Bang ports plus two MPSSE - engines used to emulate JTAG, SPI, I2C, Bit-bang or other synchronous serial modes. The FT4232H has - the following advanced Features : - - Single chip USB to quad serial ports with a variety of configurations. - Entire USB protocol handled on the chip. No USB - specific firmware programming required. - - USB 2.0 High Speed (480Mbits/Second) and Full Speed (12Mbits/Second) patible. - - Two Multi-Protocol Synchronous Serial Engine (MPSSE) on channel A and channel B, to simplify - synchronous serial protocol (USB to JTAG, I2C, - SPI or bit-bang) design. - Independent Baud rate generators. - - RS232/RS422/RS485 UART Transfer Data Rate up to 12Mbaud. (RS232 Data Rate limited by - external level shifter). - FTDI’s royalty-free Virtual Port (VCP) and - Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases. - - Optional traffic TX/RX indicators can be added - with LEDs and an external 74HC595 shift register. - - Adjustable receive buffer timeout. - - Support for USB suspend and resume conditions via PWREN#, SUSPEND# and RI# pins. - Highly integrated design includes +1.8V LDO regulator for VCORE, integrated POR function and on chip clock multiplier PLL (12MHz - 480MHz). FTDI FT232B style, asynchronous serial UART interface option with full hardware handshaking and modem interface signals. Fully assisted hardware or X-On / X-Off software handshaking. UART Interface supports 7/8-bit data, 1/2 stop bits, and Odd/Even/Mark/Space/No Parity. Auto-transmit enables control for RS485 serial applications using TXDEN pin. Operational configuration mode and USB Description strings configurable in external EEPROM over the USB interface. Low operating and USB suspend current. Configurable I/O drive strength (4, 8, 12 or 16m A) and slew rate. Supports...