Datasheet4U Logo Datasheet4U.com

EUP3595 - Parallel White-LED Driver

General Description

The EUP3595 is a parallel white-LED driver with four matched current outputs.

It can supply a total output current of 100mA over an input voltage range of 3.0V to 5.5V.

The amount of constant current sourced to the outputs is user selectable using one external sense resistor.

Key Features

  • z z z z z z z z z Regulated IOUT With ± 0.3% Matching Between Constant Current Outputs Drives One, Two, Three or Four White LED’s with No Ballast Resistors 3.0V to 5.5V Input Voltage Up to 100mA Output Current Active-High Enable Very Small Solution Size Very Low Shutdown Current (0.01µA typical) Available in TDFN-8 ,TSSOP-8 Package RoHS Compliant and 100% Lead(Pb)-Free.

📥 Download Datasheet

Datasheet Details

Part number EUP3595
Manufacturer Eutech Microelectronics
File Size 435.56 KB
Description Parallel White-LED Driver
Datasheet download datasheet EUP3595 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
EUP3427 Synchronous Step-Down Converter Eutech
EUP3618 Charge Pump Flash LED Driver Eutech
EUP7998 Sink/Source DDR Termination Regulator Eutech
EUP8090 1A Linear Li-Ion/Polymer Charger IC Eutech

Other Datasheets by Eutech Microelectronics

Part Number Description
EUP3502A 1.5A Line Switch
EUP3504 1.8A Line Switch
EUP3507 600mA Line Switch
EUP3510 1 Amp Current Limited Load Switch
EUP3511 1 Amp Current Limited Load Switch

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
EUP3595 Parallel White-LED Driver DESCRIPTION The EUP3595 is a parallel white-LED driver with four matched current outputs. It can supply a total output current of 100mA over an input voltage range of 3.0V to 5.5V. The amount of constant current sourced to the outputs is user selectable using one external sense resistor. EUP3595 typically draws 0.01µA when placed in shutdown, and 180µA when operating in the no-load condition. If any of the outputs are not used, leave the pin(s) unconnected. Brightness can be controlled by PWM techniques or by adding a DC voltage. A PWM signal can be applied to www.DataSheet4U.com the EN/PWM pin to vary the perceived brightness of the LED. The EUP3595 uses an active-high enable level. The EUP3595 is available in TDFN-8 and TSSOP-8 package.