900,000+ datasheet pdf search and download

Datasheet4U offers most rated semiconductors data sheet pdf






ETC

PVM4Wxx Datasheet Preview

PVM4Wxx Datasheet

(PVM Series) 6 Pad Leadless Surface Mount or 4 Lead Thru-Hole PECL Voltage Controlled Xtal Oscillator

No Preview Available !

Pl tronics, Inc.
.19013 36th Ave. W, Suite H Lynnwood, WA 98036 USA
Manufacturer of High Quality Frequency Control Products
PVB, PVM PECL VCXO Series
Differential PECL Output with Enable/Disable
6 Pad Leadless Surface Mount or
4 Lead Thru-Hole PECL Voltage Controlled Xtal Oscillator
1.00 MHz 650.00 MHz
Consult factory for higher frequencies
Standard Specifications
Overall Frequency Stability
Operating Temperature Range
Storage Temperature Range
Supply Voltage (Vcc)
Supply Current (Icc)
Output High Level
Output Low Level
± 50 PPM, ± 25 PPM, ± 20 PPM over Operating Temperature Range
0 to +70°C is standard, but can be extended to - 40 to +85°C
- 55 to +125°C
3.3 volts ± 5% standard, but 5.0 volts or 2.5 volts also available. See Test Cirucit 5.
< 250 MHz = 90 mA maximum, 250 MHz and above = 100 mA maximum
2.275 V minimum referenced to Ground, Vcc = 3.300V,
0.975 V minimum referenced to termination voltage,
- 1.025 V minimum referenced to Vcc
1.680 V maximum referenced to Ground, Vcc = 3.300V,
0.380 V maximum referenced to termination voltage,
- 1.620 V maximum referenced to Vcc
Output Symmetry
Output Rise & Fall (Tr & Tf)
Jitter
E/D Internal Pullup
V disable
V enable
Linerarity
Slope
Control Voltage Range (CVR)
Pullability
PVB Output Enable/Disable (E/D)
Output Enable Time
Output Disable Time
When Disabled
45/55% referenced to 50% of amplitude
1.0 nS maximum when Vth is 10% and 90% of waveform
6 pS RMS maximum measured from 12 kHz to 20 MHz from output frequency
50 kohm minimum to Vcc
0.3 Vcc maximum referenced to Ground
0.7 Vcc minumum referenced to Ground
± 10% typical
Positive and montonic
For 5.0 Vcc, CVR = 0.5 to 4.5 V, For 3.3 Vcc, CVR = 0.0 to 3.3 V, For 2.5 Vcc, CVR = 0.0 to 2.5 V
Pull range is defined as absolute pull range. This is the pull range about the specified oscillator frequency,
independent of supply, temperature range and load. Typical values are ± 25, ± 50 and ± 100 PPM.
100 nS maximum
100 nS maximum
Q Output = Logic Low, QN Output = Logic High. Both Outputs are active
Part Numbering Guide
Portions of the part number that appear after the frequency may not be marked on part (C of C provided)
Packaging
PVM = Tube
PVB = Tube or
24mm tape
16mm pitch
PVB 5 V
Model
PVB = B Pkg
PVM = Metal
Frequency Stability
5 = ± 50 PPM
4 = ± 25 PPM
2 = ± 20 PPM
Supply Voltage
Y = 5.0 volts ±10%
V = 3.3 volts ±5%
W = 2.5 volts ±5%
B V - 100.0M - XXX (Internal Code or blank)
Frequency in MHz
Frequency Deviation (Pullability) Absolute Pull Range
V: ± 50 PPM
W = ± 100 PPM
Operating Temperature Range
B: 0 to +70°C
F: - 40 to +85°C
Mar 2004
Consult factory for available frequencies and specs. Not all options available for all frequencies. A special part number may be assigned.
Frequency Stability is inclusive of frequency shifts due to calibration, temperature, supply voltage, shock, vibration and load
Pl tronics, Inc. (425) 776 -1880, Fax: (425) 776-2760, ple-sales@pletronics.com, www.pletronics.com
20




ETC

PVM4Wxx Datasheet Preview

PVM4Wxx Datasheet

(PVM Series) 6 Pad Leadless Surface Mount or 4 Lead Thru-Hole PECL Voltage Controlled Xtal Oscillator

No Preview Available !

Pl tronics, Inc.
.19013 36th Ave. W, Suite H Lynnwood, WA 98036 USA
Manufacturer of High Quality Frequency Control Products
PVB, PVM PECL VCXO Series
Mechanical: inches (mm)
not to scale
Solder Pads
Due to part size and factory abilities, part marking may vary from lot to lot and may contain our part number or an internal code.
PVB Series
0.560 (14.23) MAX
0.195 (4.95)
MAX
PVM Series
45 6
3 21
0.200 (5.08)
PIN SIGNAL
1 Vcon
2 E/D
3 GND
4 Q OUT
5 QN OUT
6 Vcc
0.200 (5.08)
6 54
1 23
0.055 0 .145
(1.4) (3.68)
20A
.807 (20.5) MAX
.200 (5.08) MAX
.031 (0.8)
.020
(.51)
.600 (15.24)
8 14
71
PIN SIGNAL
1 Vcon
7 GND
8 OUT
14 Vcc
.250 (6.35) MAX
See page 6 for Layout Guidelines
Mar 2004
Pl tronics, Inc. (425) 776 -1880, Fax: (425) 776-2760, ple-sales@pletronics.com, www.pletronics.com


Part Number PVM4Wxx
Description (PVM Series) 6 Pad Leadless Surface Mount or 4 Lead Thru-Hole PECL Voltage Controlled Xtal Oscillator
Maker ETC
PDF Download

PVM4Wxx Datasheet PDF






Similar Datasheet

1 PVM4Wxx (PVM Series) 6 Pad Leadless Surface Mount or 4 Lead Thru-Hole PECL Voltage Controlled Xtal Oscillator
ETC





Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z



Site map

Webmaste! click here

Contact us

Buy Components

Privacy Policy