The PH300 by ETC is a PEAK HOLD DETECTOR. Below is the official datasheet preview.
| Part number | PH300 |
|---|---|
| Manufacturer | ETC |
| File Size | 237.75 KB |
| Description | PEAK HOLD DETECTOR |
| Datasheet |
 PH300_ETC.pdf
|
|
|
FUNCTION IN [0 to (V+ - 1.5V)] V [-5 V to -6 V] RCEXT HRES HCAP DSCHG ISET GND DUMP [TTL control, active LOW] RAMP [TTL control, active LOW] GATE [TTL input, open HIGH] PKDT [TTL logic level] Vd [+5 V] V+ [+5 V to +12 V] COMP OUT [0 to (V+ - 1.5V) (typical)] OUTPUT CHARACTERISTICS ANALOG PIN 1 IN is the analog input of the PH300. This input accepts Range-load >5 kΩ 0 to (V+ - 1.5V) (typical) a positive signal.The input signal should not be driven greater Output slew rate 30 V/µs than the po
📁 PH300 Similar Datasheet
