Datasheet4U Logo Datasheet4U.com

ELM413 - LED Driver

General Description

The ELM413 is both an LED controller and a circuit startup timer in an 8 pin package.

The high current capabilities of its outputs allow most LEDs to be directly driven, usually only requiring a single current limiting resistor.

Key Features

  • Low power CMOS design - typically 1mA at 5V Operates over a supply range of 3.0 to 5.5 volts Schmitt trigger controlled operation Requires no external timing components Warmup periods from 0.1 to 5 seconds Auxiliary output active after warmup period High current drive outputs - up to 25 mA Connection Diagram PDIP and SOIC (top view) VDD AuxOut W1 1 2 3 4 8 7 6 5 VSS Red Green Trigger.

📥 Download Datasheet

Datasheet Details

Part number ELM413
Manufacturer ELM
File Size 42.12 KB
Description LED Driver
Datasheet download datasheet ELM413 Datasheet

📁 Similar Datasheet

Part Number Description Manufacturer
ELM452 TRANSISTOR PHOTOCOUPLER Everlight
ELM453 TRANSISTOR PHOTOCOUPLER Everlight
ELM-1081SURWA Dot Matrix Display Everlight
ELM-2001EWA Dot Matrix Display Everlight Electronics
ELM-2001GWA Dot Matrix Display Everlight Electronics

Other Datasheets by ELM

Part Number Description
ELM410 Triple Debounce Circuit
ELM411 Debounce Circuit
ELM412 Piezo Element Driver
ELM415 Up/Down Interface
ELM401 Rotary Encoder Debounce Circuit

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
ELM413 LED Driver Description The ELM413 is both an LED controller and a circuit startup timer in an 8 pin package. The high current capabilities of its outputs allow most LEDs to be directly driven, usually only requiring a single current limiting resistor. The circuit startup, or warmup feature is useful for allowing a stabilizing time period to pass before enabling other circuits. This type of function is often used in audio amplifier circuits where it is desirable to block the speaker outputs until the amplifier stages have stabilized. This can eliminate the annoying ‘pop’ occasionally heard from audio amplifiers. The duration of the warmup period is selected by logic levels on two input pins, providing four discrete time intervals.