Datasheet4U Logo Datasheet4U.com

AP3105V - COST EFFECTIVE GREEN PWM CONTROLLER

Download the AP3105V datasheet PDF. This datasheet also covers the AP3105 variant, as both devices belong to the same cost effective green pwm controller family and are provided as variant models within a single manufacturer datasheet.

Description

The AP3105/V/L/R is a low startup current, current mode PWM controller with green-mode power-saving operation.

The PWM switching frequency at normal operation is set with 65kHz typically and the dithering of frequency will also improve the EMI feature.

Features

  • a lot of functions such as the LeadingEdge Blanking (LEB) of the current sensing, internal slope compensation and several protection functions including cycle-bycycle current limit (OCP), VCC Over Voltage Protection (VOVP), OTP and OLP protection. T.

📥 Download Datasheet

Note: The manufacturer provides a single datasheet file (AP3105-Diodes.pdf) that lists specifications for multiple related part numbers.

📁 Similar Datasheet

Part Number Description Manufacturer
AP3105V High Voltage Green Mode PWM Controller BCD
AP3105 High Voltage Green Mode PWM Controller BCD
AP3105L High Voltage Green Mode PWM Controller BCD
AP3105NA High Voltage Green Mode PWM Controller BCD
AP3105NL High Voltage Green Mode PWM Controller BCD

Other Datasheets by Diodes Incorporated

Part Number Description
AP3105 COST EFFECTIVE GREEN PWM CONTROLLER
AP3105L COST EFFECTIVE GREEN PWM CONTROLLER
AP3105NA COST EFFECTIVE GREEN PWM CONTROLLER
AP3105NL COST EFFECTIVE GREEN PWM CONTROLLER
AP3105NR COST EFFECTIVE GREEN PWM CONTROLLER

Full PDF Text Transcription (Reference)

The following content is an automatically extracted verbatim text from the original manufacturer datasheet and is provided for reference purposes only.

View original datasheet text
A Product Line of Diodes Incorporated AP3105/V/L/R COST EFFECTIVE GREEN PWM CONTROLLER Description Pin Assignments The AP3105/V/L/R is a low startup current, current mode PWM controller with green-mode power-saving operation. The PWM switching frequency at normal operation is set with 65kHz typically and the dithering of frequency will also improve the EMI feature. When the load decreases, the frequency will reduce and when at a very low load, the IC will enter the „burst mode‟ to minimize switching loss. About 20kHz frequency switching is to avoid the audible noise as well as reducing the standby loss. The skip mode point can be adjusted through the external resistor connected to the current sense resistor.
Published: |