DEM33ULNA - 900-930 MHz. Low Noise Amplifier >17dB Gain
DEM23ULNA - 1240 -1300 MHz Low Noise Amplifier >17dB Gain
DEM1420ULNA - 1400 -1500 MHz Low Noise Amplifier >16dB Gain
DEM1500ULNA - 1500 -1650 MHz. Low Noise Amplifier >16dB Gain
DEM1691ULNA - 1650 -1800 MHz. Low Noise Amplifier >15dB Gain
>6dB @ design frequency
>10dB DC - 3 GHz.
+7 - +16 VDC
The DEM ULNA is a series of Ultra Low Noise Amplifiers intended to be used for Radio
Astronomy applications, amateur EME communications or weak signal satellite reception This series of
ULNA’s produced by Down East Microwave Inc. share a common design from 900 through 1800 DataShee
the latest in
figure possible. All of the ULNAs are receive only and do not provide any RF bypass switching circuitry.
Standard gains of our ULNAs range from15 - 17 dB depending on frequency. All noise figures for this
series of ULNAs are below 0.4dB. The ULNAs are adjusted on an individual basis for the best
Our ULNA design incorporates a
low loss series inductor input circuit and
a resistive loaded output circuit. During
testing, the input circuit is optimized for
gain and noise figure. The resistive
loaded output circuit, is adjusted to
control the gain and is tested for a
constant wide bandwidth output
This resistive load
impedance absorbs products caused by
reflections from band pass filters or high
Q receiver front ends. We do not use
tuned output circuits or baluns in our
ULNA designs. Tuned output circuits
and baluns do not offer constant output
impedances over wide bandwidths and may cause out of band instabilities from reflected signals.
DataSheeTt4uUn.ceodmcircuits may also require readjusting if a cable length or the characteristics of a filter changes.
DataSheet4 U .com