SCG2000 Datasheet | Connor-Winfield

Features - 3.3V High Precision PLL - Tri-State Capability - Active Alarms - Guaranteed Free Run ±20ppm - 1 Sec. Acquisition Time .. Bulletin Page Revision Date Issued By SG029 1 of 20 A04 29 JAN 02 MBATTS Rev: A04 Date: 01 / 29 / 02 © Copyright 2001 The Connor-Winfield Corp. All Rights Reserved Specifications subject to change without notice General Description The SCG2000 Series provides high precision phase lock loop frequency translation for the telemunication applications. The SCG2000 products generate a CMOS output from an intrinsically low jitter, voltage controlled crystal oscillator. Most models provide a jitter attenuated, internal reference that is connected to a Reference Output pin. SCG2000 Series is well suited for use in line cards, service termination cards and similar functions to provide reliable reference, phase locked, synchronization for TDM, PDH, SONET and SDH network equipment . The SCG2000 Series provides a low phase gain (<0.2d B), jitter filtered, wander following output signal synchronized to a superior Stratum or peer input reference signal. The SCG2000 Series include the following features : Free Run, Tri-state and alarm outputs for Loss-of-Reference, (LOR), Loss-of-Lock, (LOL). During the LOR alarm, the SCG2000 will also enter a Free Run state which will guarantee a 20 ppm accurate output. Additionally the Free Run mode may be entered manually by asserting a high signal to the Free Run Enable pin. The outputs may be put into the tri-state high impedance condition for external testing purposes by asserting a high signal to the Tri-State Enable pin. The SCG2000 Series are 3.3 Volt ponents that typically draw less than 100 m A. All models have an acquisition time of approximately 1.0 second and can be used in applications that require temperature rating of 0° 70° C. All models have a 33W resistor in series with the oscillator output. The SCG2000 package dimensions are .775” x .825” x .35” on a six layer FR4 board with surface mount...