HCPL2219 Datasheet | Avago Technologies

HCPL-2200, HCPL-2219 Low Input Current Logic Gate Optocouplers Data Sheet Description The HCPL-2200/2219 are optically coupled logic gates that bine a Ga As P LED and an integrated high gain photo detector. The detector has a three state output stage and has a detector threshold with hysteresis. The three state output eliminates the need for a pullup resistor and allows for direct drive of data busses. The hysteresis provides differential mode noise immunity and eliminates the potential for output signal chatter. Asuperiorinternalshieldon the HCPL-2219guarantees mon mode transient immunity of 2.5 k V/µs at a mon mode voltage of 400 volts. The Electrical and Switching Characteristics of the HCPL-2200/2219 are guaranteed over the temperature range of 0° C to 85° C and a VCC range of 4.5 volts to 20 volts. Low IF and wide VCC range allow patibility with TTL, LSTTL, and CMOS logic and result in lower power consumption pared to other high speed optocouplers. Logic signals are transmitted with a typical propagation delay of 160 nsec. The HCPL-2200/2219 are useful for isolating high speed logic interfaces, buffering of input and output lines, and implementing isolated line receivers in high noise environments. Functional Diagram Features - 2.5 k V/µs minimum mon Mode Rejection (CMR) at VCM = 400 V (HCPL-2219) - patible with LSTTL, TTL, and CMOS logic - Wide VCC range (4.5 to 20 V) - 2.5 Mbd guaranteed over temperature - Low input current (1.6 m A) - Three state output (no pullup resistor required) - Guaranteed performance from 0°C to 85°C - Hysteresis - Safety approval - UL recognized -3750 V rms for 1 minute - CSA approved - IEC/EN/DIN EN 60747-5-2 approved with VIORM = 630 V peak (HCPL-2219 Option 060 only) - MIL-PRF-38534 hermetic version available (HCPL-5200/1) Applications - Isolation of high speed logic systems - puter-peripheral interfaces - Microprocessor system interfaces - Ground loop elimination - Pulse transformer replacement - Isolated...