HPFC-5400 Datasheet | Agilent Technologies

Overview .. - 4K on chip boot RAM - Supports fabric, point-to-point (N_Port) and loop (Public and Private) topologies - Optional external boot ROM/Flash (128K Bytes) - Eight full-frame inbound buffers and four full-frame outbound buffers per FC channel Product Description The Tachyon DX2 is a highperformance PCI/PCI-X native dual 1 and 2 gigabit/sec Fibre Channel controller for host bus adapters and embedded subsystems. DX2 is the fourth member of the Agilent Technologies family of Fibre Channel interface controllers. It provides the performance enhancing features of PCI-X and is a single chip solution that offers the most economical ponent cost savings. The DX2 interfaces directly to an industry standard PCI/PCI-X bus. Each channel can be independently configured to use either an HSPI-patible 10-bit external SERDES or to use the internal SERDES. Features - Dual channel Fibre Channel operation on one chip for the lowest overall FC solution costs - Full duplex operation for each channel - Concurrent for each dual channel operation at full link rate - 1 and 2 gigabit Fibre Channel operation support via internal transceivers or external HSPI-patible transceivers (SERDES) - Dual function industry standard 33/66 MHz PCI or 66/100/133 MHz PCI-X backplane interface with 32/64 bit support - 3.3V PCI/PCI-X I/O - pliance to PCI Local bus Specification, Rev 2.2 - MSI (Message Signaled Interrupt) support - pliance to PCI-X Addendum, Rev 1.0A - PCI/PCI-X hot plug patible - Output impedance control on PCI-X I/O for point-to-point or multi-point connectivity - Eight GPIO pins per channel - Loss of signal indication (per channel) during internal serdes mode - Multiple split read transaction support on PCI-X - No external SRAM required for operation - State machine processing of inbound and outbound data - Fully assisted Class 2 and Class 3 FCP with simultaneous initiator and target functionality - Provision to support auto-speed negotiation in TSDK software - Full byte-level...