LUCW3011FCL Datasheet | Agere Systems

Data Sheet September 1999 W3011 1 GHz Quadrature Modulator Features + Guaranteed performance at 2.7 V power supply + Output power of 3 d Bm into 50 Ω load (singleended) with 3 V operation + Direct RF modulation with or without offset mixer + Automatic power control (APC) capability + Accurate 90° phase shifter for carrier + Double-balanced active mixers minimize carrier feedthrough (origin offset) + Low-current sleep mode modulation of an RF carrier by I & Q baseband inputs. It is particularly suited for use in mobile and handheld cellular telephones designed to the IS-136 (North American 824 MHz to 849 MHz), PDC (Japan RCR-STD27 889 MHz to 958 MHz), and other digital personal-munications standards. The circuit block diagram is shown in Figure 1. From two LO signals, LOL and LOH, the offset mixer produces an internal LO signal, which prevents the external VCOs from being pulled by the large transmitted signal. The phase shifter splits the LO signal into two carriers with 90° phase separation and equal amplitude. These signals are fed to the in-phase (I) and quadrature-phase (Q) double-balanced mixers. The resulting signals are summed and fed into the output amplifier. This amplifier can provide 0 d Bm linear output power, minimum, into a 50 Ω load. The output power can be attenuated up to 50 d B by applying a control voltage to the APC input. Nominally, the output power is at maximum (+3 d Bm) with VAPC > 2.2 V, and at minimum (- 50 d Bm) with VAPC < 0.8 V. A CMOS/TTL-patible logic input allows the device to be put into a powerdown mode in which less than 10 µA of supply current is consumed. I BIAS AND CONTROL VCC ENABLE GROUND LOH IN 50 Ω Applications + PDC 800 and American digital cellular mobile terminals + Cellular base stations Description The W3011 1 GHz Quadrature Modulator is a monolithic integrated circuit that provides direct - π/4 RFOUT ∑ φ +π/4 Q LOL IN 50 Ω EXTERNAL FILTER OR DIRECT LO INPUT Figure 1. Circuit Block Diagram W3011 1 GHz...