ATA8210
ATA8210 is UHF ASK/FSK Receiver manufactured by Atmel.
Features
- AVR® microcontroller core with 1Kbyte SRAM and 24Kbyte RF library in firmware
(ROM)
- Atmel® ATA8210: 20Kbyte of user Flash
- Atmel ATA8215: No user memory
- RF library in firmware only
- Supported frequency ranges
- Low-band 310MHz to 318MHz, 418MHz to 477MHz
- High-band 836MHz to 956MHz
- 315.00MHz/433.92MHz/868.30MHz and 915.00MHz with one 24.305MHz crystal
- Low current consumption
- 9.8m A for RXMode (Low-band), 1.2m A for 21ms cycle three-channel polling
- Typical OFFMode current of 5n A (maximum 600n A at Vs = 3.6V and T = 85°C)
- Supports the 0d Bm class of ARIB STD-T96
- Input 1d B pression point
- - 48d Bm (full sensitivity level)
- - 20d Bm (active antenna damping)
- Programmable channel frequency with fractional-N PLL
- 93Hz resolution for Low-band
- 185Hz resolution for High-band
- FSK deviation ±0.375k Hz to ±93k Hz
- FSK sensitivity (Manchester coded) at 433.92MHz
- - 108.5d Bm at 20Kbit/s f = ±20k Hz BWIF = 165k Hz
- - 111d Bm at 10Kbit/s
f = ±10k Hz BWIF = 165k Hz
- - 114d Bm at 5Kbit/s
f = ±5k Hz
BWIF = 165k Hz
- - 122.5d Bm at 0.75Kbit/s f = ±0.75k Hz BWIF = 25k Hz
- ASK sensitivity (Manchester coded) at 433.92MHz
- - 110.5d Bm at 20Kbit/s BWIF = 80k Hz
- - 125d Bm at 0.5Kbit/s
BWIF = 25k Hz
- Programmable Rx-IF bandwidth 25k Hz to 366k Hz (approximately 10% steps)
- Blocking (BWIF = 165k Hz): 64d Bc at frequency offset = 1MHz and 48d Bc at 225k Hz
- High image rejection: 55d B at 315MHz/433.92MHz and 47d B at 868.3MHz/915MHz without calibration
- Supported data rate in buffered mode 0.5Kbit/s to 80Kbit/s (120Kbit/s NRZ)
9344E-INDCO-11/15
- Supports pattern-based wake-up and start of frame identification
- Flexible service configuration concept with on-the-fly (OTF) modification (in IDLEMode) of SRAM service...
