http://www.www.datasheet4u.com

900,000+ Datasheet PDF Search and Download

Datasheet4U offers most rated semiconductors datasheets pdf




Xicor
Xicor


X1205

Real Time Clock/Calendar



No Preview Available !

X1205 pdf
Preliminary Information
New Features
Repetitive Alarms &
Temperature Compensation
X1205
Real Time Clock/Calendar
2-WireRTC
FEATURES
• Real Time Clock/Calendar
—Tracks time in Hours, Minutes, and Seconds
—Day of the Week, Day, Month, and Year
• 2 Polled Alarms (Non-volatile)
—Settable on the Second, Minute, Hour, Day of
the Week, Day, or Month
—Repeat Mode (periodic interrupts)
• Oscillator Compensation on chip
—Internal feedback resistor and compensation
capacitors
—64 position Digitally Controlled Trim Capacitor
—6 digital frequency adjustment settings to
±30ppm
• Battery Switch or Super Cap Input
• 2-Wire™ Interface interoperable with I2C*
—400kHz data transfer rate
• Low Power CMOS
—1.25µA Operating Current (Typical)
• Small Package Options
—8-Lead SOIC and 8-Lead TSSOP
APPLICATIONS
• Utility Meters
• HVAC Equipment
• Audio / Video Components
• Set Top Box / Television
• Modems
• Network Routers, Hubs, Switches, Bridges
• Cellular Infrastructure Equipment
• Fixed Broadband Wireless Equipment
• Pagers / PDA
• POS Equipment
• Test Meters / Fixtures
• Office Automation (Copiers, Fax)
• Home Appliances
• Computer Products
• Other Industrial / Medical / Automotive
DESCRIPTION
The X1205 device is a Real Time Clock with clock/
calendar, two polled alarms, oscillator compensation,
and battery backup switch.
The oscillator uses an external, low-cost 32.768kHz
crystal. All compensation and trim components are
integrated on the chip. This eliminates several external
discrete components and a trim capacitor, saving
board area and component cost.
The Real-Time Clock keeps track of time with separate
registers for Hours, Minutes, and Seconds. The
Calendar has separate registers for Date, Month, Year
and Day-of-week. The calendar is correct through
2099, with automatic leap year correction.
BLOCK DIAGRAM
OSC
Compensation
32.768kHz
X1
X2
Oscillator
Frequency 1Hz
Divider
Timer
Calendar
Logic
Time
Keeping
Registers
(SRAM)
SCL
SDA
Serial
Interface
Decoder
IRQ
Control
Decode
Logic
8
*I2C is a Trademark of Philips.
REV 1.0.9 8/29/02
Control
Registers
(EEPROM)
Status
Registers
(SRAM)
Interrupt Enable
Alarm
www.xicor.com
Alarm
Compare
Alarm Regs
(EEPROM)
Characteristics subject to change without notice. 1 of 22



No Preview Available !

X1205 pdf
X1205 – Preliminary Information
DESCRIPTION (continued)
The powerful Dual Alarms can be set to any Clock/
Calendar value for a match. For instance, every
minute, every Tuesday, or 5:23 AM on March 21. The
alarms can be polled in the Status Register or provide
a hardware interrupt (IRQ Pin). There is a repeat
mode for the alarms allowing a periodic interrupt.
The device offers a backup power input pin. This
VBACK pin allows the device to be backed up by battery
or SuperCap. The entire X1205 device is fully
operational from 2.7 to 5.5 volts and the clock/calendar
portion of the X1205 device remains fully operational
down to 1.8 volts (Standby Mode).
PIN DESCRIPTIONS
X1205
X1, X2
The X1 and X2 pins are the input and output,
respectively, of an inverting amplifier. An external
32.768kHz quartz crystal is used with the X1205 to
supply a timebase for the real time clock. The
recommended crystal is a Citizen CFS206-32.768KDZF.
Internal compensation circuitry is included to form a
complete oscillator circuit. Care should be taken in the
placement of the crystal and the layout of the circuit.
Plenty of ground plane around the device and short
traces to X1 and X2 are highly recommended. See
Application section for more recommendations.
Figure 1. Recommended Crystal connection
X1
X2
X1
X2
IRQ
VSS
8-Pin SOIC
18
27
36
45
VCC VBACK
VBACK VCC
SCL X1
SDA
X2
8-Pin TSSOP
18
27
36
45
SCL
SDA
VSS
IRQ
NC = No internal connection
Serial Clock (SCL)
The SCL input is used to clock all data into and out of
the device. The input buffer on this pin is always active
(not gated).
Serial Data (SDA)
SDA is a bidirectional pin used to transfer data into and
out of the device. It has an open drain output and may
be wire ORed with other open drain or open collector
outputs. The input buffer is always active (not gated).
An open drain output requires the use of a pull-up
resistor. The output circuitry controls the fall time of the
output signal with the use of a slope controlled pull-
down. The circuit is designed for 400kHz 2-wire inter-
face speeds.
VBACK
This input provides a backup supply voltage to the
device. VBACK supplies power to the device in the
event the VCC supply fails. This pin can be connected
to a battery, a Supercap or tied to ground if not used.
Interrupt Output – IRQ
This is an interrupt signal output. This signal notifies a
host processor that an alarm has occurred and
requests action. It is an open drain active low output.
POWER CONTROL OPERATION
The power control circuit accepts a VCC and a VBACK
input. The power control circuit powers the clock from
VBACK when VCC < VBACK - 0.2V. It will switch back to
power the device from VCC when VCC exceeds VBACK.
Figure 2. Power Control
VBACK
VCC
Off
Voltage
On
In
REAL TIME CLOCK OPERATION
The Real Time Clock (RTC) uses an external
32.768kHz quartz crystal to maintain an accurate inter-
nal representation of second, minute, hour, day, date,
month, and year. The RTC has leap-year correction.
The clock also corrects for months having fewer than
31 days and has a bit that controls 24 hour or AM/PM
format. When the X1205 powers up after the loss of
both VCC and VBACK, the clock will not operate until at
least one byte is written to the clock register.
Reading the Real Time Clock
The RTC is read by initiating a Read command and
specifying the address corresponding to the register of
the Real Time Clock. The RTC Registers can then be
read in a Sequential Read Mode. Since the clock runs
continuously and a read takes a finite amount of time,
there is the possibility that the clock could change during
REV 1.0.9 8/29/02
www.xicor.com
Characteristics subject to change without notice. 2 of 22



Part Number X1205
Description Real Time Clock/Calendar
Maker Xicor - Xicor
Total Page 22 Pages
PDF Download
X1205 pdf
Download PDF File
X1205 pdf
View for Mobile




Featured Datasheets

Part Number Description Manufacturers PDF
X1205 Real Time Clock/Calendar X1205
Xicor
PDF
X120FG Diode (spec sheet) X120FG
American Microsemiconductor
PDF
X120SG Diode (spec sheet) X120SG
American Microsemiconductor
PDF
X120UFG Diode (spec sheet) X120UFG
American Microsemiconductor
PDF
X1226 Real Time Clock/Calendar with EEPROM X1226
Xicor
PDF
X1226 Real Time Clock/Calendar X1226
Intersil Corporation
PDF


Part Number Start With

0  1  2  3  4  5  6  7  8  9  A  B  C  D  E  F  G  H  I  J  K  L  M  N  O  P  Q  R  S  T  U  V  W  X  Y  Z

site map

webmaste! click here

contact us

Buy Components