http://www.www.datasheet4u.com

900,000+ Datasheet PDF Search and Download

Datasheet4U offers most rated semiconductors datasheets pdf




ETC
ETC


H11-A1

H11A1



No Preview Available !

H11-A1 pdf
MOTOROLA
SEMICONDUCTOR TECHNICAL DATA
www.DataSheet4U.com
GlobalOptoisolator
6-Pin DIP Optoisolators
Transistor Output
The H11A1 device consists of a gallium arsenide infrared emitting diode
optically coupled to a monolithic silicon phototransistor detector.
Current Transfer Ratios (CTR) 30% and 50%
Economical Optoisolators for General Purpose/High Volume Applications
To order devices that are tested and marked per VDE 0884 requirements, the
suffix ”V” must be included at end of part number. VDE 0884 is a test option.
Applications
General Purpose Switching Circuits
Interfacing and coupling systems of different potentials and impedances
Monitor and Detection Circuits
MAXIMUM RATINGS (TA = 25°C unless otherwise noted)
Rating
Symbol
Value
Unit
INPUT LED
Reverse Voltage
Forward Current — Continuous
LED Power Dissipation @ TA = 25°C
with Negligible Power in Output Detector
Derate above 25°C
VR 3 Volts
IF 60 mA
PD 120 mW
1.41 mW/°C
OUTPUT TRANSISTOR
Collector–Emitter Voltage
Emitter–Collector Voltage
Collector–Base Voltage
Collector Current — Continuous
Detector Power Dissipation @ TA = 25°C
with Negligible Power in Input LED
Derate above 25°C
VCEO
VECO
VCBO
IC
PD
30 Volts
7 Volts
70 Volts
150 mA
150 mW
1.76 mW/°C
TOTAL DEVICE
Isolation Surge Voltage(1)
(Peak ac Voltage, 60 Hz, 1 sec Duration)
VISO
7500
Vac(pk)
Total Device Power Dissipation @ TA = 25°C
Derate above 25°C
PD 250 mW
2.94 mW/°C
Ambient Operating Temperature Range(2)
Storage Temperature Range(2)
TA – 55 to +100
Tstg – 55 to +150
°C
°C
Soldering Temperature (10 sec, 1/16from case)
TL 260 °C
1. Isolation surge voltage is an internal device dielectric breakdown rating.
1. For this test, Pins 1 and 2 are common, and Pins 4, 5 and 6 are common.
2. Refer to Quality and Reliability Section in Opto Data Book for information on test conditions.
Preferred devices are Motorola recommended choices for future use and best overall value.
GlobalOptoisolator is a trademark of Motorola, Inc.
REV 1
©MMoottoorroolal,aInOc.p1t9o9e5lectronics Device Data
Order this document
by H11A1/D
H11A1 *
[CTR = 50% Min]
*Motorola Preferred Device
STYLE 1 PLASTIC
61
STANDARD THRU HOLE
CASE 730A–04
SCHEMATIC
16
25
34
PIN 1. LED ANODE
2. LED CATHODE
3. N.C.
4. EMITTER
5. COLLECTOR
6. BASE
1



No Preview Available !

H11-A1 pdf
H11A1
ELECTRICAL CHARACTERISTICS (TA = 25°C unless otherwise noted)(1)
Characteristic
Symbol
INPUT LED
wwFowr.wDaartdaSVhoeltaegt4eU(.IcFo=m10 mA,
TA = 25°C)
TA = –55°C
TA = 100°C
VF
Reverse Leakage Current (VR = 3 V)
Capacitance (V = 0 V, f = 1 MHz)
OUTPUT TRANSISTOR
IR
CJ
Collector–Emitter Dark Current (VCE = 10 V)
TA = 25°C
TA = 100°C
ICEO
Collector–Base Dark Current (VCB = 10 V)
TA = 25°C
TA = 100°C
ICBO
Collector–Emitter Breakdown Voltage (IC = 10 mA)
V(BR)CEO
Collector–Base Breakdown Voltage (IC = 100 µA)
V(BR)CBO
Emitter–Collector Breakdown Voltage (IE = 100 µA)
V(BR)ECO
DC Current Gain (IC = 5 mA, VCE = 5 V) (Typical Value)
hFE
Collector–Emitter Capacitance (f = 1 MHz, VCE = 0 V)
CCE
Collector–Base Capacitance (f = 1 MHz, VCB = 0 V)
CCB
Emitter–Base Capacitance (f = 1 MHz, VEB = 0 V)
CEB
COUPLED
Output Collector Current (IF = 10 mA, VCE = 10 V) H11A1
IC (CTR)(2)
Collector–Emitter Saturation Voltage (IC = 0.5 mA, IF = 10 mA)
Turn–On Time (IF = 10 mA, VCC = 10 V, RL = 100 )(3)
Turn–Off Time (IF = 10 mA, VCC = 10 V, RL = 100 )(3)
Rise Time (IF = 10 mA, VCC = 10 V, RL = 100 )(3)
Fall Time (IF = 10 mA, VCC = 10 V, RL = 100 )(3)
Isolation Voltage (f = 60 Hz, t = 1 sec)(4)
Isolation Resistance (V = 500 V)(4)
Isolation Capacitance (V = 0 V, f = 1 MHz)(4)
VCE(sat)
ton
toff
tr
tf
VISO
RISO
CISO
1. Always design to the specified minimum/maximum electrical limits (where applicable).
2. Current Transfer Ratio (CTR) = IC/IF x 100%.
3. For test circuit setup and waveforms, refer to Figure 11.
4. For this test, Pins 1 and 2 are common, and Pins 4, 5 and 6 are common.
Min
30
70
7
5 (50)
7500
1011
Typ(1)
1.15
1.3
1.05
0.01
18
1
1
0.2
100
45
100
7.8
500
7
19
9
12 (120)
0.1
2.8
4.5
1.2
1.3
0.2
Max Unit
1.5 Volts
10 µA
— pF
50 nA
µA
20 nA
— Volts
— Volts
— Volts
——
— pF
— pF
— pF
— mA (%)
0.4 Volts
µs
µs
µs
µs
— Vac(pk)
— pF
2 Motorola Optoelectronics Device Data



Part Number H11-A1
Description H11A1
Maker ETC - ETC
Total Page 6 Pages
PDF Download
H11-A1 pdf
Download PDF File
H11-A1 pdf
View for Mobile




Featured Datasheets

Part Number Description Manufacturers PDF
H11-A1 H11A1 H11-A1
ETC
PDF
H11-C1 H11C1 H11-C1
ETC
PDF


Part Number Start With

0  1  2  3  4  5  6  7  8  9  A  B  C  D  E  F  G  H  I  J  K  L  M  N  O  P  Q  R  S  T  U  V  W  X  Y  Z

site map

webmaste! click here

contact us

Buy Components