INTERNAL PULL-UP HALL EFFECT LATCH
AH372 is a single-digital-output Hall-Effect latch sensor with internal
pull-up resistor for high temperature operation. The device includes
an on-chip Hall voltage generator for magnetic sensing, an amplifier
to amplify Hall voltage, and a comparator to provide switching
hysteresis for noise rejection, and an output driver with a pull-up
resistor. An internal band-gap regulator provides a temperature
compensated supply voltage for internal circuits and allows a wide
operating supply range.
When the magnetic flux density (B) perpendicular to the package is
larger than operation point (BOP), output is switched on (OUT pin is
pulled low). The output state is held on until a magnetic flux density
reversal falls below BRP. When B is less than BRP, the output is
The AH372 is available in SIP-3 (Ammo Pack), SIP-3 (Bulk Pack),
SC59 and SOT23 packages.
Bipolar Hall Effect Latch Operation
2.2V to 20V Operating Range
Single Output with Built-in Pull-up Resistor
25mA output Sink Capability
-40°C to +125°C Operating Temperature
Industry Standard SIP-3 (Ammo Pack), SIP-3 (Bulk Pack), SC59
and SOT23 Packages
Totally Lead-Free & Fully RoHS Compliant (Notes 1 & 2)
Halogen and Antimony Free. “Green” Device (Note 3)
SC59 and SOT23
SIP-3 (Bulk Pack)
Rotor Position Sensing for Motor Commutation
Speed Measurement – RPM Monitor
Contact-Less Current Switch
1. No purposely added lead. Fully EU Directive 2002/95/EC (RoHS) & 2011/65/EU (RoHS 2) compliant.
2. See http://www.diodes.com/quality/lead_free.html for more information about Diodes Incorporated’s definitions of Halogen- and Antimony-free, "Green"
3. Halogen- and Antimony-free "Green‖ products are defined as those which contain <900ppm bromine, <900ppm chlorine (<1500ppm total Br + Cl) and
<1000ppm antimony compounds.
Typical Application Circuits
Hall Motor Driver
Document number: DS38853 Rev. 1 - 2
Digital Hall Effect Sensor
M: Three Phase Hall Motor
3 Phase Hall Motor
1 of 12
© Diodes Incorporated