http://www.www.datasheet4u.com

900,000+ Datasheet PDF Search and Download

Datasheet4U offers most rated semiconductors datasheets pdf



  Microchip Technology Semiconductor Electronic Components Datasheet  


93C56

2K 5.0V Automotive Temperature Microwire Serial EEPROM


No Preview Available !

93C56 pdf
M
93C56A/B
2K 5.0V Automotive Temperature Microwire® Serial EEPROM
FEATURES
• Single supply 5.0V operation
• Low power CMOS technology
- 1 mA active current (typical)
- 1 µA standby current (maximum)
• 256 x 8 bit organization (93C56A)
• 128 x 16 bit organization (93C56B)
• Self-timed ERASE and WRITE cycles (including
auto-erase)
• Automatic ERAL before WRAL
• Power on/off data protection circuitry
• Industry standard 3-wire serial interface
• Device status signal during ERASE/WRITE
cycles
• Sequential READ function
• 100,000 E/W cycles guaranteed
• Data retention > 200 years
• 8-pin PDIP and SOIC packages
• Available for the following temperature ranges:
- Automotive (E):
-40°C to +125°C
DESCRIPTION
The Microchip Technology Inc. 93C56A/B is a 2K-bit,
low-voltage serial Electrically Erasable PROM. The
device memory is configured as 256 x 8 bits (93C56A)
or 128 x 16 bits (93C56B). Advanced CMOS technol-
ogy makes this device ideal for low-power, nonvolatile
memory applications. The 93C56A/B is available in
standard 8-pin DIP and surface mount SOIC packages.
This device is only recommeded for 5V automotive
temperature applications. For all commercial and
industrial applications, the 93LC56A/B is recom-
mended.
PACKAGE TYPE
PDIP
CS
VCC
1
CLK 2
DI 3
DO 4
8
7 NC
6 NC
5 VSS
SOIC
CS
CLK
DI
DO
1
2
3
4
8 VCC
7 NC
6 NC
5 VSS
BLOCK DIAGRAM
MEMORY
ARRAY
ADDRESS
DECODER
ADDRESS
COUNTER
DI
CS
CLK
DATA
REGISTER
MEMORY
DECODE
LOGIC
CLOCK
GENERATOR
OUTPUT
BUFFER
DO
VCC
VSS
Microwire is a registered trademark of National Semiconductor.
© 1998 Microchip Technology Inc.
Preliminary
DS21206B-page 1



No Preview Available !

93C56 pdf
93C56A/B
1.0 ELECTRICAL
CHARACTERISTICS
1.1 Maximum Ratings*
VCC ...................................................................................7.0V
All inputs and outputs w.r.t. VSS ................ -0.6V to Vcc +1.0V
Storage temperature .....................................-65°C to +150°C
Ambient temp. with power applied.................-65°C to +125°C
Soldering temperature of leads (10 seconds) ............. +300°C
ESD protection on all pins................................................4 kV
*Notice: Stresses above those listed under “Maximum ratings” may
cause permanent damage to the device. This is a stress rating only and
functional operation of the device at those or any other conditions
above those indicated in the operational listings of this specification is
not implied. Exposure to maximum rating conditions for extended peri-
ods may affect device reliability.
TABLE 1-1: PIN FUNCTION TABLE
Name
Function
CS Chip Select
CLK Serial Data Clock
DI Serial Data Input
DO Serial Data Output
VSS Ground
NC No Connect
VCC Power Supply
TABLE 1-2: DC AND AC ELECTRICAL CHARACTERISTICS
All parameters apply over the Automotive (E)VCC = +4.5V to +5.5VTamb = -40°C to +125°C
specified operating ranges
unless otherwise noted
Parameter
Symbol Min.
Max.
Units
Conditions
High level input voltage
VIH
2.0 VCC +1
V (Note 2)
Low level input voltage
VIL -0.3 0.8
V
Low level output voltage
VOL — 0.4 V IOL = 2.1 mA; VCC = 4.5V
High level output voltage
VOH
2.4
V IOH = -400 µA; VCC = 4.5V
Input leakage current
ILI -10 10 µA VIN = VSS to VCC
Output leakage current
ILO -10 10 µA VOUT = VSS to VCC
Pin capacitance
(all inputs/outputs)
CIN, COUT
7
pF
VIN/VOUT = 0 V (Notes 1 & 2)
Tamb = +25°C, FCLK = 1 MHz
Operating current
ICC write
ICC read
1.5 mA
1 mA
Standby current
ICCS
1
µA CS = VSS
Clock frequency
FCLK
2 MHz
Clock high time
TCKH
250
ns
Clock low time
TCKL
250
ns
Chip select setup time
TCSS
50
ns Relative to CLK
Chip select hold time
TCSH
0
— ns Relative to CLK
Chip select low time
TCSL
250
ns
Data input setup time
TDIS
100
ns Relative to CLK
Data input hold time
TDIH
100
ns Relative to CLK
Data output delay time
TPD — 400 ns CL = 100 pF
Data output disable time
TCZ — 100 ns CL = 100 pF (Note 2)
Status valid time
TSV — 500 ns CL = 100 pF
TWC
2 ms ERASE/WRITE mode
Program cycle time
TEC
6 ms ERAL mode
TWL
15 ms WRAL mode
Endurance
— 100K — cycles 25°C, VCC = 5.0V, Block Mode (Note 3)
Note 1: This parameter is tested at Tamb = 25°C and FCLK = 1 MHz.
2: This parameter is periodically sampled and not 100% tested.
3: This application is not tested but guaranteed by characterization. For endurance estimates in a specific
application, please consult the Total Endurance Model which may be obtained on Microchip’s BBS or web-
site.
DS21206B-page 2
Preliminary
© 1998 Microchip Technology Inc.



Part Number 93C56
Description 2K 5.0V Automotive Temperature Microwire Serial EEPROM
Maker Microchip Technology - Microchip Technology
Total Page 12 Pages
PDF Download
93C56 pdf
Download PDF File
93C56 pdf
View for Mobile




Featured Datasheets

Part Number Description Manufacturers PDF
93C06 256 Bit/1K 5.0V CMOS Serial EEPROM 93C06
Microchip Technology
PDF
93C06-EJ 256 Bit/1K 5.0V CMOS Serial EEPROM 93C06-EJ
Microchip Technology
PDF
93C06-EP 256 Bit/1K 5.0V CMOS Serial EEPROM 93C06-EP
Microchip Technology
PDF
93C06-ESM 256 Bit/1K 5.0V CMOS Serial EEPROM 93C06-ESM
Microchip Technology
PDF
93C06-ESN 256 Bit/1K 5.0V CMOS Serial EEPROM 93C06-ESN
Microchip Technology
PDF
93C06-IJ 256 Bit/1K 5.0V CMOS Serial EEPROM 93C06-IJ
Microchip Technology
PDF


Part Number Start With

0  1  2  3  4  5  6  7  8  9  A  B  C  D  E  F  G  H  I  J  K  L  M  N  O  P  Q  R  S  T  U  V  W  X  Y  Z

site map

webmaste! click here

contact us

Buy Components