BI-DIRECTIONAL TRIODE THYRISTOR ILICON PLANAR TYPE

www.DataSheet4U.com SM25GZ51,SM25JZ51 TOSHIBA BI−DIRECTIONAL TRIODE THYRISTOR ILICON PLANAR TYPE SM25GZ51,SM25JZ51 AC POWER CONTROL APPLICATIONS l Repetitive Peak Off−State Voltage : VDRM = 400, 600V l R.M.S On−State Current l High Commutating (dv / dt) l Isolation Voltage : IT (RMS) = 25A : (dv / dt) c = 10V / µs : VIsol = 1500V AC Unit: mm MAXIMUM RATINGS CHARACTERISTIC Repetitive Peak Off−State Voltage SM25GZ51 SM25JZ51 SYMBOL VDRM IT (RMS) ITSM It (Note 1) di / dt PGM PG (AV) VGM IGM Tj Tstg VIsol 2 RATING 400 600 25 230 (50Hz) 253 (60Hz) 260 50 5 0.5 10 2 −40~125 −40~125 1500 UNIT V A A As A / µs W W V A °C °C V 2 R.M.S On−State Current (Full Sine Waveform Tc = 73°C) Peak One Cycle Surge On−State Current (Non-Repetitive) I t Limit Value Critical Rate of Rise of On−State Current Peak Gate Power Dissipation Average Gate Power Dissipation Peak Gate Voltage Peak Gate Current Junction Temperature Storage Temperature Range Isolation Voltage (AC, t = 1 min.) 2 JEDEC JEITA TOSHIBA Weight: 5.9g ― ― 13−16A1A Note 1: di / dt Test Condition VDRM = 0.5 × Rated ITM ≤ 40A tgw ≥ 10µs tgr ≤ 250ns igp = IGT × 2.0 1 2001-07-13 www.DataSheet4U.com SM25GZ51,SM25JZ51 ELECTRICAL CHARACTERISTICS (Ta = 25°C) CHARACTERISTIC Repetitive Peak Off−State Current I Gate Trigger Voltage II III I Gate Trigger Current II III Peak On−State Voltage Gate Non−Trigger Voltage Holding Current Thermal Resistance Critical Rate of Rise of Off−State Voltage Critical Rate of Rise of Off−State Voltage at Commutation VTM VGD IH Rth (j−c) dv / dt (dv / dt) c ITM = 40A VD = Rated, Tc = 125°C VD = 12V, ITM = 1A Junction to Case, AC VDRM = Rated, Tj = 125°C Exponential Rise VDRM = 400V, Tj = 125°C (di / dt) c = − 15A / ms IGT VD = 12V RL = 20Ω VGT VD = 12V RL = 20Ω SYMBOL IDRM TEST CONDITION VDRM = Rated T2 (+) , Gate (+) T2 (+) , Gate (−) T2 (−) , Gate (−) T2 (+) , Gate (+) T2 (+) , Gate (−) T2 (−) , Gate (−) MIN ― ― ― ― ― ― ― ― 0.2 ― ― ― 10 TYP. ― ― ― ― ― ― ― ― ― ― ― 300 ― MAX 20 1.5 1.5 1.5 30 30 30 1.5 ― 60 1.3 ― ― V V mA °C / W V / µs V / µs mA V UNIT µA MARKING NUMBER *1 TYPE SYMBOL SM25GZ51 SM25JZ51 MARK M25GZ51 M25JZ51 *2 Example 8A : January 1998 8B : February 1998 8L : December 1998 2 2001-07-13 www.DataSheet4U.com SM25GZ51,SM25JZ51 3 2001-07-13 www.DataSheet4U.com SM25GZ51,SM25JZ51 4 2001-07-13 www.DataSheet4U.com SM25GZ51,SM25JZ51 RESTRICTIONS ON PRODUCT USE 000707EAA · TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the “Handling Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability Handbook” etc.. · The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.). These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury (“Unintended Usage”). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in this document shall be made at the customer’s own risk. · The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA CORPORATION for any infringements of intellectual property or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any intellectual property or other rights of TOSHIBA CORPORATION or others. · The information contained herein is subject to change without notice. 5 2001-07-13