(RI-TRP-xR2B) 32mm Glass Transponder

RADIO FREQUENCY IDENTIFICATION SYSTEMS Data Sheet 32mm Glass Transponder Specifications: Part number Functionality Memory (Bits) Memory (Pages) Operating Frequency Modulation Transmission Principle Power Source Typical Reading Range Typical Programming Range Typical Read Time Typical Programming Time Typical Programming Cycles Operating Temperature (Read) Operating Temperature (Program) Storage Temperature Case Material Protection Class EMC Signal Penetration Mechanical Shock Vibration Dimensions Weight RI-TRP-RR2B Read Only 64 1 134.2 kHz RI-TRP-WR2B Read/Write 80* 1 RI-TRP-DR2B MPT 1360* 17*R/W RI-TRP-IR2B SAMPT 1360* 17*R/W*** FSK (Frequency Shift Keying) 134.2 kHz / 123.2 kHz HDX (Half Duplex) Powered from the reader signal (batteryless) ≤ 100 cm** --70 ms -----25 to +85°C ---25 to +70°C -25 to +85°C 309 ms 100,000 30 % of specified reading range 86 ms 293 ms 341 ms -40 to +100°C (+125°C for total 1000 hours) Glass Hermetically sealed Programmed code is not affected by normal electromagnetic interference or x-rays Transponder can be read through virtually all non-metallic material IEC 68-2-27, Test Ea; 300 g, half sine, 3 ms, 2 axes IEC 68-2-6, Test Fc; 3 g, 5 - 50 Hz, 2 axes, 24 hours per axis 20 g, 10 - 2000 Hz, 2 axes, 2.5 hours per axis ∅ 3.85 ± 0.05 mm * 31.2 ± 0.6 mm 0.8 g ∅ 3.85 ± 0.05 mm * 32.2 ± 0.6 mm * We recommend that you split each 80 bit page into 64 user programmable bits plus a 16 bit wide CRC CCITT Block Check Character as is done by TI-RFID readers. ** Depending on RF regulation in country of use, the Reader Antenna configuration used, and the environmental conditions. *** 24 bits Selective Address width. For more information, contact the sales office or distributor nearest you. This contact information can be found on our web site at: http://www.ti-rfid.com Texas Instruments reserves the right to change its products and services at any time without notice. TI provides customer assistance in various technical areas, but does not have full access to data concerning the uses and applications of customers products. Therefore, TI assumes no responsibility for customer product design or for infringement of patents and/or the rights of third parties, which may result from assistance provided by TI. © Copyright 2001 Texas Instruments Incorporated. Data Sheet: 11-09-22-081 09/01