Mount-on-Metal Transponder

www.DataSheet4U.com RADIO FREQUENCY IDENTIFICATION SYSTEMS Data Sheet Mount-on-Metal Transponder Specifications: Part Number Functionality Memory (Bits) Memory (Pages) Operating Frequency Modulation Transmission Principle Power Source Typical Reading Range Typical Programming Range Typical Reading Time Typical Programming Time Typical Programming Cycles Operating Temperature Storage Temperature Case Material Protection Class Mounting EMC Signal Penetration Mechanical Shock Vibration Dimensions Weight Read Only 64 1 134.2 kHz FSK (Frequency Shift Keying) 134.2 kHz / 123.2 kHz HDX (Half Duplex) Powered from the reader signal (batteryless) ≤ 120 cm** --70 ms -----25 to +70°C*** -25 to +85°C Polypropylene, black IP 67 ( product revision –11 ) With screws or rivets on aluminum, iron or steel Programmed code is not affected by normal electromagnetic interference or x-rays Transponder can be read through virtually all non-metallic material IEC 68-2-27, Test Ea; 200 g, half sine, 3 ms, 3 axes, 6 shocks per axis IEC 68-2-6, Test Fc; 20 g, 20 - 500 Hz, 3 axes, 10 cycles per axis 102 mm ± 1 mm * 36 mm ± 1 mm * 16.5 mm ± 1 mm 43 g 309 ms 100,000 30 % of typical reading range RI-TRP-R9VS Read/Write 80* 1 RI-TRP-W9VS * We recommend that you split each 80 bit page into 64 user programmable bits plus a 16 bit wide CRC CCITT Block Check Character as is done by TI-RFID LF readers. ** Depending on RF regulation in country of use, the Reader Antenna configuration used, and the environmental conditions. *** Reduced operating temperature of 0 to +70°C if used with Series 2000 Standard Reader (RI-STU-MB2A/MB6A) or Standard RFM (RI-RFM-104B) For more information, contact the sales office or distributor nearest you. This contact information can be found on our web site at: http://www.ti-rfid.com Texas Instruments reserves the right to change its products and services at any time without notice. TI provides customer assistance in various technical areas, but does not have full access to data concerning the uses and applications of customers products. Therefore, TI assumes no responsibility for customer product design or for infringement of patents and/or the rights of third parties, which may result from assistance provided by TI. © Copyright 2001 Texas Instruments Incorporated. Data Sheet: 11-09-22-065 07/01