LOW COST - HIGH PERFORMANCE PHASE LOCKED LOOP

www.DataSheet4U.com 9939 Via Pasar • San Diego, CA 92126 TEL (858) 621-2700 FAX (858) 621-2722 PCA0163A PHASE LOCKED LOOP Rev A1 PHASE NOISE (1 Hz BW, typical) -70 -80 -90 -100 FEATURES • Frequency Range: 163.84 - 163.84 MHz • Step Size: 80 KHz • cPLL - Style Package APPLICATIONS • Telecommunications • Satellite • Telemetry PERFORMANCE SPECIFICATIONS Frequency Range RMS Phase Error (100 Hz - 100 KHz) Harmonic Suppression (2nd, typ.) Sideband Spurs (typ.) Power Output Load Impedance Step Size Charge Pump Output Current Switching Speed (typ., adjacent channel) Startup Lock Time (typ.) Operating Temperature Range Package Style -110 -120 -130 -140 2 10 10 3 10 4 10 5 VALUE 163.84 - 163.84 1.0 -10 -70 0±2 50 80 1250 n/a 4 -40 to 85 cPLL 3 21 APPLICATION NOTES UNITS MHz ° dBc dBc dBm Ω KHz µΑ mSec mSec °C POWER SUPPLY REQUIREMENTS Supply Voltage (Vcc, nom.) Supply Current (Icc, typ.) Vdc mA All specifications are typical unless otherwise noted and subject to change without notice. • AN-107 : How to Solder Z-COMM VCOs / PLLs • AN-200 : Mounting and Grounding of Z-COMM PLLs • AN-201 : PLL Fundamentals AN-202 : PLL Functional Description NOTES: Reference Oscillator Signal: 5 MHz< f osc <100 MHz Frequency Synthesizer: Analog Devices - ADF4001 © Z-Communications, Inc. Page 1 All rights reserved LOW COST - HIGH PERFORMANCE PHASE LOCKED LOOP www.DataSheet4U.com PCA0163A PAGE 2 PLL OUTPUT SPECTRUM POWER FREQUENCY OFFSET (KHz) POWER CURVE, typ. 25 °c PHYSICAL DIMENSIONS 12 11 10 1. The inside radius of all 14 half holes at the perimeter of the board are plated to provide a surface for the attachment of the PLL Module to the motherboard. 5 pads are for grounding, 8 pads are for signal interface. 2. The surface of the shield is tin-plated and may be soldered to. 1 9 The shield's base metal is brass. 3.The ground plane on the bottom side is ground and attaches to a ground track on the top side of the board as well as to the shield. 4. Unless otherwise noted all dimensions are in inches. 5.Unless otherwise noted all tolerances are as follows: .xxx = ± .010 Bottom View 2 Top View 8 3 7 P1 RF OUTPUT P2 REFERENCE OSCILLATOR INPUT P3 CLOCK P4 DATA P5 LOAD ENABLE P6 LOCK DETECT 4 5 6 SIDE VIEW P7 VCC P8 GROUND P9 NO CONNECTION P10-12 GROUND © Z-Communications, Inc. Page 2 Printed in the U.S.A.