(MPSA06 / MPSA56) AMPLIFIER TRANSISTOR

UTC MPSA06/56 NPN MPSA06 PNP MPSA56 FEATURES *Collector-Emitter Voltage: VCEO=80V *Collector Dissipation: PD=625mW AMPLIFIER TRANSISTOR 1 TO-92 1: EMITTER 2: BASE 3: COLLECTOR ABSOLUTE MAXIMUM RATINGS (TA=25°C, unless otherwise specified) PARAMETER Collector-base voltage Collector-emitter voltage Emitter-base voltage Collector current - Continuous Total device dissipation, @TA=25°C Derate above 25°C Total device dissipation, @TC=25°C Derate above 25°C Junction Temperature Storage Temperature SYMBOL VCBO VCEO VEBO www.DataSheet4U.com Ic PD PD Tj TSTG RATING 80 80 4 500 625 5 1500 12 -55 ~ +150 -55 ~ +150 UNIT V V V mA mW mW/°C mW mW/°C °C °C THERMAL CHARACTERISTICS PARAMETER SYMBOL MAX UNIT °C/W °C/W Thermal resistance, junction to ambient RθJA (note) 200 Thermal resistance, junction to case RθJC 83.3 Note: RθJA is measured with the device soldered into a typical printed circuit board. ELECTRICAL CHARACTERISTICS (Ta=25°C, unless otherwise specified) PARAMETER OFF CHARACTERISTICS Collector-emitter breakdown voltage (note 1) Emitter-base breakdown voltage Collector cutoff current Collector cutoff current SYMBOL V(BR)CEO V(BR)EBO ICES ICBO TEST CONDITIONS IC=1.0mA, IB=0 IE=100µA, Ic=0 VCE=60V, IB=0 VCB=80V, IE=0 MIN 80 4 TYP MAX UNIT V V µA µA 0.1 0.1 UTC UNISONIC TECHNOLOGIES CO., LTD. 1 QW-R201-035,A UTC MPSA06/56 PARAMETER ON CHARACTERISTICS DC current gain Collector-emitter saturation voltage Base-emitter on voltage SMALL-SIGNAL CHARACTERISTICS Current gain bandwidth product (note 2) AMPLIFIER TRANSISTOR SYMBOL hFE VCE(sat) VBE(on) fT TEST CONDITIONS IC=10mA, VCE=1V IC=100mA, VCE=1V IC=100mA, IB=10mA IC=100mA, VCE=1V MPSA06: IC=10mA, VCE=2V, f=100MHz MPSA56: IC=100mA, VCE=1V, f=100MHz MIN 100 100 TYP MAX UNIT 0.25 1.2 V V 100 50 MHz MHz Note 1: Pulse test: PW<=300µs, Duty Cycle<=2% Note 2: fT is defined as the frequency at which IhfeI extrapolates to unity. SWITCHING TIME TEST CIRCUITS Figure 1 (Note: Total shunt capacitance of test jig and connectors for PNP test circuits, reverse all voltage polarities.) MPSA06 MPSA56 CURRENT-GAIN BANDWIDTH PRODUCT Figure 2 Figure 3 UTC UNISONIC TECHNOLOGIES CO., LTD. 2 QW-R201-035,A UTC MPSA06/56 MPSA06 AMPLIFIER TRANSISTOR MPSA56 CAPACITANCE Figure 4 Figure 5 SWITCHING TIME Figure 6 Figure 7 ACTIVE-REGION SAFE OPERATING AREA Figure 8 Figure 9 UTC UNISONIC TECHNOLOGIES CO., LTD. 3 QW-R201-035,A UTC MPSA06/56 MPSA06 AMPLIFIER TRANSISTOR MPSA56 DC CURRENT GAIN Figure 10 Figure 11 “ON” VOLTAGES Figure 12 Figure 13 COLLECTOR SATURATION REGION Figure 14 Figure 15 UTC UNISONIC TECHNOLOGIES CO., LTD. 4 QW-R201-035,A UTC MPSA06/56 MPSA06 AMPLIFIER TRANSISTOR MPSA56 BASE-EMITTER TEMPERATURE COEFFICIENT Figure 16 Figure 17 THERMAL RESPONSE Figure 18 UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UTC UNISONIC TECHNOLOGIES CO., LTD. 5 QW-R201-035,A