SNAP ACTION SWITCH SPDT LEVER 5A 250VAC

Snap-action Microswitches – Ultraminiature F1 F1 Characteristics Long electrical rating from a very small switch Gold plated contacts PCB mounting from side UL and CSA approved A Rating Up to 250 VAC, 5 A Dimensions (mm) 16 x 6.5 x 5.7 Actuator Plunger, plain lever Approvals UL, CSA www.DataSheet4U.com Preferred Product Range Ordering Actuating Force Reference (N) (oz) Sealing Operating position (mm) (in) Terminal Circuit Actuator Contacts Electrical rating F1T8GPUL 1.4 F1T8Y1GPUL 0.5 5.04 1.80 IP40 IP40 6.35 8.50 0.25 0.33 PCB PCB CO CO Plunger Lever Gold plate Gold plate Up to 250 VAC, 5 A Up to 250 VAC, 5 A saia-burgess Switches Ph: 800-429-0365 www.saia-burgess-usa.com Fax: 847-549-9625 A5 Snap-action Microswitches – Ultraminiature F1 Specifications Housing Plunger A Mechanism Functions Contacts Terminals Temperature range ºC Mechanical life Protection www.DataSheet4U.com Mounting Actuators Circuit diagram 2 NORMALLY CLOSED Glass fiber reinforced nylon Nylon Snap-action, coil spring mechanism with stainless steel spring Single pole change-over Gold plate on silver PCB - copper, gold-flashed –40°C to +85°C 106 cycles minimum (impact-free actuation) IP40 (enclosure) Side mount PCB with locating pin on housing Plain plunger, straight lever COMMON 1 4 NORMALLY OPEN Ø 1.8 ± 0.05 [0.07] Ø 2.0 ± 0.05 [0.08] 0.50 [0.02] MAX [0.16] 2.0 [0.08] Ø 2.60 [0.1] 6.5 MAX [0.26] 3° ENLARGED VIEW OF PEG 2.9 [0.11] 1.1 [0.04] ENLARGED VIEW OF PEG 2.9 [0.11] 3° 6.5 MAX [0.26] 4.15 [0.16] 8.60 [0.34] 1.25 [0.05] 1.40 [0.06] 4.05 [0.16] FREE POSITION 1.1 [0.04] 4.15 [0.16] 8.60 [0.34] 17.9 3 [0.71 ] 1.25 [0.05] 4.85 5.7 [0.22] 5.1 MAX [0.2] [0.19] 3.1 [0.12] FREE POSITION OPERATING POSITION 2.54 [0.1] OPERATING POSITION 2.03 [0.08] 5.7 MAX [0.22] 2 2 4 1 4 1 0.50 [0.02] 2.54 [0.1] 4.62 [0.05] 0.50 [0.02] 1.50 [0.2] 1.35 8.6 [0.34] 1.35 [0.05] 16.0 MAX [0.63] F1T8GPUL 1.5X FULL SIZE 8.6 [0.34] 16.0 [0.63] MAX F1T8Y1GPUL 1.5X FULL SIZE Recommended Maximum Electrical Ratings Voltage (max) Resistive load (A) Inductive load Approval 250 VAC 0 - 15 VDC 15 - 30 VDC 5 (0.75 pf) 5 10 5 10 UL 1054/CSA 22.2 No. 55 - 6,000 operations General rating - 50,000 operations General rating - 50,000 operations F1 switches have gold-plated silver contacts. Switches with gold-plated contacts are intended for use in circuits where switching is at milliwatt levels. In this case, the power being switched must be limited to avoid the erosion of gold plate from the contact area. However, as the underlying contacts are silver, the same power ratings apply. A6 saia-burgess Switches Ph: 800-429-0365 www.saia-burgess-usa.com Fax: 847-549-9625 [0.06] [0.18] 1.50 4.1 [0.16] 2.0 [0.08] 1.40 [0.06] 2.3 [0.09] Ø 2.0 ± 0.05 [0.08] 0.50 [0.02] MAX Dimensions mm [in] 4.0 Ø 2.60 [0.1] Ø 1.8 ± 0.05 [0.07] 3 EQUI-SPACED RIBS R0.1 [0.04] 3 EQUI-SPACED RIBS R0.1 [0.04] Snap-action Microswitches – Ultraminiature F1 Operating Characteristics Actuator Reference Actuating Force Maximum (N) (oz) Release Force Minimum (N) (oz) Free Position Maximum (mm) (in) Operating Position (mm) (in) Movement Differential Maximum (mm) (in) Over Travel A * Plunger F1T8GPUL 2 1.4 5.00 0.28 1.00 7.1 0.28 6.35 ± 0.38 0.25 ± 0.015 0.1 0.004 4 1 www.DataSheet4U.com Straight lever mm [in] F1T8Y1GPUL 17.9 3 [0.71 ] 0.5 1.8 0.06 0.022 11.0 0.43 8.5 ± 1.5 0.33 ± 0.06 0.5 0.02 * 2 4 1 Width of lever 4.05 mm/0.16 in Roller lever mm [in] DIA 4.8 x 3.2 [0.19] [0.13] 16.0 [0.63 ] Free Position Operating Position F1T8YR1GPUL 0.5 1.8 0.08 0.3 16.0 0.63 13.9 ± 1.3 0.55 ± 0.05 0.3 0.012 * 2 4 1 * Plunger can be depressed flush with housing. The housing should not be used as an end stop. Ordering Reference – How to Build a Part Number F1 Terminals T8 Circuit No digit Actuators No digit PCB Change-over Plunger Plain lever Roller lever Gold plate on silver UL and CSA Y1 YR1 Contacts GP Approvals UL saia-burgess Switches Ph: 800-429-0365 www.saia-burgess-usa.com Fax: 847-549-9625 A7