Clock Oscillator

CMO5 Series 5 x 7 mm, 5.0 Volt, CMOS/TTL, Clock Oscillator CMO5 Series THIS PRODUCT IS NOT RECOMMENDED FOR NEW DESIGNS. 5V 5x7mm Surface Mount Crystal Clock Oscillators PLEASE REFER TO THE M1 PRODUCT SERIES. TTL/CMOS Compatible Tri-State Feature for Auto Test Systems Tape & Reel Packaging ±20ppm Available - Please Contact Factory E L E C T R I C A L S P E C I F I C AT I O N S MODEL Frequency Range (MHz) Frequency Stability (ppm) Overall (Typical) 0°C to 70°C -40°C to +85°C Temperature Range (°C) Operating Storage Supply Voltage (V) Input Current (mA) Symmetry (%) TTL/CMOS Transistion Times Rise Time (ns) Fall Time (ns) Load “0” Level (VOL) “1” Level (VOH) Start up Time (ms) 1.5MHz to 50MHz <5 <5 10TTL/15pF 0.5V 2.4V/4.5V <10 1.5MHz to 30MHz <10 <30 45/55 >50MHz to 156.250MHz <3 <3 -40°C to +85°C -40°C to +125°C +5.0 ±10% >30MHz to 50MHz >50MHz to 156.250MHz <50 Inclusive of calibration, temperature, voltage, load, shock,vibration, aging ±25 ±50 CMO5 1.5 to 156.250 PA R T N U M B E R I N G G U I D E CMO5XXXX - Specify Frequency “C” = CMOS “T” = TTL “Blank” = 0oC to 70oC Operating Temp. “M” = -40oC to 85oC Operating Temp. “B” = ±50ppm “C” = ±100ppm “D” = ±20ppm Excluding Aging (Contact Factory) “Blank” = Fixed Frequency “E” = Tri-State MtronPTI reserves the right to make changes to the product(s) and service(s) described herein without notice. No liability is assumed as a result of their use or application. “A” = ±25ppm (-40oC to 85oC Excluding Aging) 2553 N. Edgington Street, Franklin Park, IL 60131 Fax: 847.451.7585 Please see www.mtronpti.com for our complete offering and detailed datasheets. Contact Phone: 847.451.1000 requirements: MtronPTI 1-800-762-8800. us for your application specific 800-888-1499 or www.champtech.com Revision: 03-01-07 CMO5 Series CMO5 Series 5V 5x7mm Surface Mount Crystal Clock Oscillators PIN 1 FUNCTION 5 x 7 mm, 5.0 Volt, CMOS/TTL, Clock Oscillator N/C / Tri-State THIS PRODUCT IS NOT RECOMMENDED FOR NEW DESIGNS. 2 Ground PLEASE REFER TO THE M1 PRODUCT SERIES. 4 PIN 1 2 3 4 + VCC FUNCTION CMO5 Series 5V 5x7mm Surface Mount Crystal Clock Oscillators 3 Output N/C / Tri-State Ground Output + VCC OUTPUT WAVEFORM TEST CIRCUIT DIAGRAM OUTPUT WAVEFORM TEST CIRCUIT DIAGRAM MECHANICAL AND ENVIRONMENTAL SPECIFICATIONS TEST METHODS Temperature Cycle Mechanical Shock Vibration REFERENCE PROCEDURES MIL-STD-833, Mtd 1010, Cond. B MIL-STD-883, Mtd 2002, Cond. B MIL-STD 883, Mtd 2007, Cond. B DESCRIPTION -55°C to +125°C; Air-to-Air; 100 cycles; 10 min. dwell 1500 g’s 20-2000 Hz; 0.06 inch; 15g’s; 3 planes MECHANICAL AND ENVIRONMENTAL SPECIFICATIONS MIL-STD-883, Mtd 1011.7 Cond. B MIL-STD-833, Mtd 1010, Cond. B MIL-STD-883, Mtd 3015 Class II MIL-STD-883, Mtd 2002, MIL-STD-883, Mtd 2022.2 Cond. B MIL-STD-202, Mtd 103 REFERENCE PROCEDURES 40°C; 90%-95% R.H.; 56 days DESCRIPTION HumidityMETHODS TEST Steady State Thermal Shock Temperature Cycle Electrostatic Discharge Mechanical Solderability Shock Hermeticity Vibration ResistanceSteady State Humidity to Soldering Lead Integrity Thermal Shock Marking Permanence Electrostatic Discharge Life Test Solderability Hermeticity Resistance to Soldering Lead Integrity Life Test 100°C to 0°C; Water-to-Water; 15 cycles; 10 -55°C to +125°C; Air-to-Air; 100 cycles 2 min.to 4 KV Threshold KV dwell 1500 dip; Solder g’s Meniscograph Criteria MIL-STD-883, Mtd 1014.8, Cond. B Mass spectro. 0.0610-8 atmos. CC/sec He MIL-STD 883, Mtd 2007, Cond. A1 20-2000 Hz; 2 x inch; 15g’s; 3 planes MIL-STD-202, Mtd 210D, Cond. J 235°C; 30 seconds MIL-STD-202, Mtd 103 40°C; 90%-95% R.H.; 56 days MIL-STD-883, Mtd 2004.5, Cond. A, B1 Lead tension & bend stress 100°C to 0°C; Water-to-Water; 15 cycles MIL-STD-883, Mtd 1011.7 Cond. B MIL-STD-883, Mtd 2015.8 Class II MIL-STD-883, Mtd 3015 MIL-STD-883, Mtd 1005.6 MIL-STD-883, Mtd 2022.2 MIL-STD-883, Mtd 1014.8, Cond. A1 Resistance KVsolvents 2 KV to 4 to Threshold Solder dip; Meniscograph Criteria 125°C, powered, 1000 hours minimum Phone: 847.451.1000 2553 N. Edgington Street, Franklin Park, IL 60131 Mass spectro. 2 x 10-8 atmos. CC/sec He MIL-STD-883, Mtd 2015.8 Resistance specific requirements: MtronPTI 1-800-762-8800. PleaseMarking Permanence our complete offering and detailed datasheets. Contact us for your application to solvents see www.mtronpti.com for MIL-STD-883, Mtd 1005.6 MtronPTI reserves the right to make changes to the product(s) and service(s) described herein without notice. No liability is assumed as a result of their use or application. MIL-STD-202, Mtd 210D, Cond. J 235°C; 30 seconds MIL-STD-883, Mtd 2004.5, www.champtech.com Cond. A, B1 Lead tension & bend stress 800-888-1499 or Fax: 847.451.7585 2 125°C, powered, 1000 hours minimum 2553 N. Edgington Street, Franklin Park, IL 60131 Phone: 847.451.1000 Revision: 03-01-07 Fax: 847.451.7585 MtronPTI Lead Free Solder Profile MtronPTI reserves the right to make changes to the product(s) and service(s) described herein without notice. No liability is assumed as a result of their use or application. Please see www.mtronpti.com for our complete offering and detailed datasheets. Contact us for your application specific requirements: MtronPTI 1-800-762-8800.